So I have my TIVO plugged into the HDMI1 and an HDMI out to the TV. The HDMI out to the TV has ARC enabled so if I want to record 2 channels on the TIVO I can watch a third on the TV's freeveiw receiver.
All goes well and good while everything is powered up. I can switch between the TIVO and TV with 1 press of a button, the receiver will always switch over to either not a problem. The problem is when I boot it all up from standby, I want the receiver to start up on the TIVO, and it does for about 5 seconds until the HDMI control from the TV tells it to turn onto the TV. So I end up with the TIVO output on the TV and no sound because it has switched to the TV's ARC input.
Hope that is clear as mud. All I am looking to do is have the TV turn on, stay on the TIVO input, the receiver to stay on the TIVO input and still have the HDMI control to switch everything over with 1 press of a button.
Any takers?
... 
