When running a Dynalink RTA1320 in half bridge (IP extension) should it pass through more than one DNS server when it serves the IP address to the router?
I've got one running 3.64y firmware. It picks up two DNS servers assigned by the ISP when you look at the status page, but whatever device you connect to the 1320 only gets one of these servers.
Can anyone else running one in half bridge confirm if they see the same thing?
Yes, this does seem to be the case. My setup is a RTA1320 on a TelstraClear ADSL connection, receiving its address information via DHCP. The modem is bridged to a router running Tomato firmware.
$ telnet modem Trying 10.0.0.1... Connected to Modem. Escape character is '^]'. Dynalink ADSL2+ Router RTA1320NZ TelstraClear Software Version: 3.30j Login name: Password: > cat /etc/resolv.conf nameserver 203.97.78.44 nameserver 203.97.78.43
Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly
to your computer or smartphone by using a feed reader.