Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.
Filter this topic showing only the reply marked as answer View this topic in a long page with up to 500 replies per page Create new topic
1 | 2 | 3 | 4 | 5 | 6
1894 posts

Uber Geek
+1 received by user: 369

Subscriber

  Reply # 2017344 17-May-2018 09:16
2 people support this post
Send private message

We wait with bated breath.......


4760 posts

Uber Geek
+1 received by user: 1929


  Reply # 2017387 17-May-2018 09:21
Send private message

So if you are trying all the possible combinations what are the chances of hitting on some that match your neighbours doors?





Mike

1486 posts

Uber Geek
+1 received by user: 334


  Reply # 2017406 17-May-2018 09:36
Send private message

I'd be pulling a sheet of iron or a weatherboard or flexing a door/opening to either trigger the manual release or push the remote button. Putty or rubber out of the window frame? You've got to get a bit creative sometimes when it comes to entry techniques.

61 posts

Master Geek
+1 received by user: 7


  Reply # 2017490 17-May-2018 11:07
Send private message

kiwijunglist:

That's excellent do they live in Wellington would they rent it for a few hours. I can buy the same remote from nz for about $80, however have seen on ebay Australia for a lot less.

Are you fairly confident with those specs you quoted, are they from memory or from the link i posted.

Thanks.

 

 

 

Apologies for the delay, I didn't subscribe to the thread and it isn't the usual topic I lurk on so I didn't see it.  But my folks aren't in Wellington unfortunately, though I could check with them to see if they are happy for me to send you the remote to try.  Having said that, it looks like you have a couple of remotes ordered and awaiting receipt of.

But the specs were as I quoted - I took some photos of it the other day, and will post them here (hopefully they aren't too oversized - forum image uploading can be treacherous).  I did change the switch combination before taking the snaps in case anyone was wondering!

 

Click to see full size

 

Click to see full size

 

Anyhow, let me know how you get on and if you require any assistance..!

 

Cheers,
Yann

 

 




2674 posts

Uber Geek
+1 received by user: 93


  Reply # 2017511 17-May-2018 11:28
Send private message

From memory that looks the same except the button colour. I'm pretty sure the inside is the same as well.

I've ordered replacement remotes linked above and hopefully they will open my garage when i run through the codes.




HTPC: Intel i3-2100 / 12GB RAM / AMD HD7750 / 480 GB SSD / 58TB Storage / MediaPortal / MadVR / Win10
AVR: Pioneer Elite SC-LX87 220W 9.2 Ch AVR
Speakers: Wharfedale Jade 7 Fronts / Jade 2c Center / Jade 5 Rears
Subs: iNuke 3000dsp 3000W proamp with 4x 15" JBL Sealed Subs
Display: Samsung 60" UA60H6400 LCD TV
Accessories: Gefen HDMI Detective with splitter


3354 posts

Uber Geek
+1 received by user: 647

Trusted

  Reply # 2017533 17-May-2018 11:37
Send private message

I had one pretty similar to that, one remote didnt work.  Ordered 2cheap ones off ebay 

 

https://www.ebay.com/itm/TRG-Doormate-700T-Garage-Remote-TRG300-306-TR300-TRV300-303-TRG107-TiltAMatic-/282916456444?hash=item41df2287fc

 

 

 

Just 8 dip switches.  I had to guess the combination of one door, took me about 6 attempts ( I got very lucky, i wasnt doing them in order, i was just wildly guessing).


14205 posts

Uber Geek
+1 received by user: 1826


  Reply # 2017537 17-May-2018 11:41
One person supports this post
Send private message

Doors that use this  remote don't seem much more secure than a briefcase with the 3 digit pin.


250 posts

Master Geek
+1 received by user: 67


  Reply # 2017587 17-May-2018 12:20
Send private message

What were you ever to do during a power cut. Ours has a key on side of garage. Turn key pull out lock that is attached to the manual override course. Pull cord detaches motor from drum and lift door



2674 posts

Uber Geek
+1 received by user: 93


  Reply # 2017594 17-May-2018 12:29
Send private message

Turn key nothing happened. Lock is screwed in to wall. Am i supposed to turn key then pull out the whole mechanism? Then that will pull on the disengage cord?

I can try this. I assumed the lock was an additional lock for the door rather than a release mechanism.




HTPC: Intel i3-2100 / 12GB RAM / AMD HD7750 / 480 GB SSD / 58TB Storage / MediaPortal / MadVR / Win10
AVR: Pioneer Elite SC-LX87 220W 9.2 Ch AVR
Speakers: Wharfedale Jade 7 Fronts / Jade 2c Center / Jade 5 Rears
Subs: iNuke 3000dsp 3000W proamp with 4x 15" JBL Sealed Subs
Display: Samsung 60" UA60H6400 LCD TV
Accessories: Gefen HDMI Detective with splitter


6977 posts

Uber Geek
+1 received by user: 3630


  Reply # 2017607 17-May-2018 12:44
Send private message

kiwijunglist: Turn key nothing happened. Lock is screwed in to wall. Am i supposed to turn key then pull out the whole mechanism?

 

Yes.  May need some wiggling of the key, the whole barrel should come out with wire to the manual release lever attached.

 

Note that some of the new auto units with a c-channel rather than a chain on a pole, the manual release lever releases a pin which may lock into several holes in the channel. You need to get past those holes before the door will open freely without continuing to hold the manual release lever down.


14205 posts

Uber Geek
+1 received by user: 1826


  Reply # 2017630 17-May-2018 13:29
Send private message

Many of them won;t have the handle and key connected at all, and the handle on the outside is solely for show. That is how it is on our one. Luckily we do have a door going into the garage to get access when the door decides to die.


3239 posts

Uber Geek
+1 received by user: 848


  Reply # 2017635 17-May-2018 13:37
Send private message

Fred99:

 

kiwijunglist: Turn key nothing happened. Lock is screwed in to wall. Am i supposed to turn key then pull out the whole mechanism?

 

Yes.  May need some wiggling of the key, the whole barrel should come out with wire to the manual release lever attached.

 

 

+1

 

A good squirt of CRC will help too. turn the key and wiggle until the barrel comes out and brings a steel wire with it, then pull to disengage the motor mechanism...




2674 posts

Uber Geek
+1 received by user: 93


  Reply # 2017793 17-May-2018 17:13
Send private message

So I'll disengage the motor.
Lift up the roller door.
Get inside the garage
Put the roller door back onto the ground
Then is there another wire that will reengage the motor?

I assume i want to reengage the motor with the door fully closed as that was the position when i disengaged it?




HTPC: Intel i3-2100 / 12GB RAM / AMD HD7750 / 480 GB SSD / 58TB Storage / MediaPortal / MadVR / Win10
AVR: Pioneer Elite SC-LX87 220W 9.2 Ch AVR
Speakers: Wharfedale Jade 7 Fronts / Jade 2c Center / Jade 5 Rears
Subs: iNuke 3000dsp 3000W proamp with 4x 15" JBL Sealed Subs
Display: Samsung 60" UA60H6400 LCD TV
Accessories: Gefen HDMI Detective with splitter


327 posts

Ultimate Geek
+1 received by user: 37


  Reply # 2017800 17-May-2018 17:33
Send private message

Do you have something like this:

 


82 posts

Master Geek
+1 received by user: 20

Subscriber

  Reply # 2017814 17-May-2018 18:10
Send private message

kiwijunglist: So I'll disengage the motor.
Lift up the roller door.
Get inside the garage
Put the roller door back onto the ground
Then is there another wire that will reengage the motor?

I assume i want to reengage the motor with the door fully closed as that was the position when i disengaged it?

There is a mechanism attached to the end of the wire, just push it up.
It doesn’t matter when you engage the mechanism the door position is indexed, re-engage it up or down.

Edit, corrected autocorrect

1 | 2 | 3 | 4 | 5 | 6
Filter this topic showing only the reply marked as answer View this topic in a long page with up to 500 replies per page Create new topic

Twitter »

Follow us to receive Twitter updates when new discussions are posted in our forums:



Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:



Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:





News »

Intel introduces new NUC kits and NUC mini PCs
Posted 16-Aug-2018 11:03


The Warehouse leaps into the AI future with Google
Posted 15-Aug-2018 17:56


Targus set sights on enterprise and consumer growth in New Zealand
Posted 13-Aug-2018 13:47


Huawei to distribute nova 3i in New Zealand
Posted 9-Aug-2018 16:23


Home robot Vector to be available in New Zealand stores
Posted 9-Aug-2018 14:47


Panasonic announces new 2018 OLED TV line up
Posted 7-Aug-2018 16:38


Kordia completes first live 4K TV broadcast
Posted 1-Aug-2018 13:00


Schools get safer and smarter internet with Managed Network Upgrade
Posted 30-Jul-2018 20:01


DNC wants a safer .nz in the coming year
Posted 26-Jul-2018 16:08


Auldhouse becomes an AWS Authorised Training Delivery Partner in New Zealand
Posted 26-Jul-2018 15:55


Rakuten Kobo launches Kobo Clara HD entry level reader
Posted 26-Jul-2018 15:44


Kiwi team reaches semi-finals at the Microsoft Imagine Cup
Posted 26-Jul-2018 15:38


KidsCan App to Help Kiwi Children in Need
Posted 26-Jul-2018 15:32


FUJIFILM announces new high-performance lenses
Posted 24-Jul-2018 14:57


New FUJIFILM XF10 introduces square mode for Instagram sharing
Posted 24-Jul-2018 14:44



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.