Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.




1545 posts

Uber Geek

Trusted

# 108974 10-Sep-2012 14:33
Send private message

Hi,

Signed up for the free Orcon install. Still waiting for a date but they rung today to get a few details. They also suggested I watch their video of an install (which I did - http://www.youtube.com/watch?v=Hs__8cAvfmA&feature=plcp)

Now, with the OTN, where are people placing these things?

We have a 80's Lockwood. The current copper line terminates in the kitchen. I'd like to put the OTN somewhere else - I see its powered so near a outlet would be handy!

Current thinking is behind the TV cabinet or beneath some shelves along one wall of the lounge.

Where are people placing these things inside there house?

Thanks

Create new topic
2055 posts

Uber Geek

Subscriber

  # 683880 10-Sep-2012 14:57
Send private message

Hi. I have just had a UFB/Orcon/Chorus installation. I put a lot of thought into where the ONT should go, but when all is said and done, it just needs a quiet spot with power and an ethernet cable to your Genius modem/router.

My choices were on a garage wall not far from the ETP, under the house (dry, full head room space), or alongside my computer in our rumpus room.

I settled for under the house so the Chorus guys ran the fibre across the garage frontage, along the wall and through the wall to the under house area. From there I ran an ethernet cable through to my Genius router sitting close to my computer. The Genius was just a straight swap with my Thompson modem/router, basically.

Someone else had it put behind their TV. This didn't appeal to me but it would have worked fine as well.

I am sure wherever you decide will be fine.

28363 posts

Uber Geek

Moderator
Trusted
Biddle Corp
Lifetime subscriber

  # 683897 10-Sep-2012 15:12
Send private message

The current line of thinking is that if no wiring/distribution cupboard exists that the best place is near the TV - it's typically a central point, has power, and also typically has multiple ethernet capable devices in your average home.

 
 
 
 




1545 posts

Uber Geek

Trusted

  # 683926 10-Sep-2012 15:38
Send private message

Mmmm good to know.

I might put it behind the TV then as its hidden from view and (like you said, its handy to plug in the Blu-Ray, games systems and TV etc).

If it were under the house, I assume the OTN reasonably weather proof? Its not like Id put my Thomson router down there!

A few more Q's;

- What are the typical dimensions of the OTN?
- Does it run hold/cold?
- When you said "ran the fibre across the garage frontage", how thick is this fibre cable? I'm wondering if they could push this up alongside my sky cable into the house?

Thanks guys for your input :D



1545 posts

Uber Geek

Trusted

  # 683930 10-Sep-2012 15:43
Send private message

From another post;

OTN dimensions are 180mm x 120mm x 50mm

6771 posts

Uber Geek

Trusted
Lifetime subscriber

  # 683939 10-Sep-2012 15:54
Send private message

My current copper comes into the garage, and I have my modem on the wall. My intention is to put the ONT (not OTN) in the same place when Chorus finally gets around to doing my street. There's a nearby power point and Ethernet cable which goes to my router, so I'm expecting to keep the same sort of configuration.

Does anyone know what the "output" of the ONT is? Will I just need to enter PPPoE settings into my router or is it more complicated than that?

3344 posts

Uber Geek

Trusted
Vocus

  # 683942 10-Sep-2012 15:57
Send private message

Behodar: My current copper comes into the garage, and I have my modem on the wall. My intention is to put the ONT (not OTN) in the same place when Chorus finally gets around to doing my street. There's a nearby power point and Ethernet cable which goes to my router, so I'm expecting to keep the same sort of configuration.

Does anyone know what the "output" of the ONT is? Will I just need to enter PPPoE settings into my router or is it more complicated than that?


It'll depend on the ISP; in the case of Orcon you just need to use tagged VLAN 10 (or the Genius which is pre-configured).  No PPPoE etc.

28363 posts

Uber Geek

Moderator
Trusted
Biddle Corp
Lifetime subscriber

  # 683943 10-Sep-2012 15:58
Send private message

PPPoE on VLAN10 for Chorus, I'm not 100% sure if every other RSP is using VLAN10 also.

 
 
 
 




1545 posts

Uber Geek

Trusted

  # 683948 10-Sep-2012 16:03
Send private message

Behodar: My current copper comes into the garage, and I have my modem on the wall. My intention is to put the ONT (not OTN) in the same place when Chorus finally gets around to doing my street. There's a nearby power point and Ethernet cable which goes to my router, so I'm expecting to keep the same sort of configuration.

Does anyone know what the "output" of the ONT is? Will I just need to enter PPPoE settings into my router or is it more complicated than that?


Thanks. Yeah the Orcon video shows the ONT in the garage which is I guess is ideal except our garage isn't attached to the house and I guess it also assumes the house is wired up with CAT5.

Judging by other install photos/stories on Geeksone, looks like behind the TV is best.

Our copper terminates out a metal pipe under the house Surprised - not convinced they will want to go there.

BTW, another install post said they rewired the copper at the same time. Is this usual? He did mention he had to ask for this, I think it was referred to as a hybrid install.

2055 posts

Uber Geek

Subscriber

  # 684114 10-Sep-2012 21:20
Send private message

It is a bit irrelevant picking the TV location because of the supposed number of ethernet cables required there as the ONT is not a distribution routing device. It has one ethernet port so has to be connected to a router for distribution. If you choose the same location for the modem/router you have established that area for distributing to the rest of the house devices. It may not be an easy place to get cables to and from. You have to think of the best place in your own house to act as the distribution point.

In addition, most of us have so many wires behind the TV that the thought of adding two more multi cabled devices is not very appealing, especially if you have to wheel out the big TV and cabinet to get behind it!

In my case I already had an ethernet cable behind the TV feeding a wifi router so that area was covered.

The ONT placement is a bit irrelevant, actually. A lot of the time you choose to run a longer fibre and shorter ethernet cable or vice versa. Or you could make it awkward and require both runs to be long ones!

You will work out a good solution. Good luck.

3413 posts

Uber Geek

Trusted

  # 685276 13-Sep-2012 02:07
Send private message

I would advise to have it near your tv.

The network is designed for tv broadcast like any other fibre based cable netwok, and if using an IP decoder, your tv will probably be the big bandwidth consumer.
With the increased interference when telecom started handing out wifi routers for free, which resulted in less wifi range in most homes a few years ago, it means running a decoder using wifi is not practical.

The alternative is running cat5 from the ONT to the TV but that isnt always the easy, and homeplug / home PNA is still not good with distance either - even though it promises 80mbit+ but over a very short distance.

So i suggest place your ONT near your tv, and then you can distribute the signal from your decoder throughout your home using the existing RF coaxial cables like many homes with SKY currently do.

Even though there is no current need for it, you never know what UFB will be used for in the future and i believe tv is going to be one of the big bandwidth using services.




Ray Taylor
Taylor Broadband (rural hawkes bay)
www.ruralkiwi.com

There is no place like localhost
For my general guide to extending your wireless network Click Here




3413 posts

Uber Geek

Trusted

  # 685277 13-Sep-2012 02:08
Send private message

sorry - duplicate post




Ray Taylor
Taylor Broadband (rural hawkes bay)
www.ruralkiwi.com

There is no place like localhost
For my general guide to extending your wireless network Click Here




2055 posts

Uber Geek

Subscriber

  # 685367 13-Sep-2012 09:36
Send private message

Surely, you are going to need an ethernet cable to the modem and network as well? In that case, why is it easier to run this cable FROM the TV area rather than TO it?

Or are you suggesting the modem also lives behind the TV, and the rest of the network is fed via wireless?

6434 posts

Uber Geek


  # 685370 13-Sep-2012 09:49
Send private message

depends entirely on the house I think.

If, like me, your house is single level, wood construction, and has very easy access to underfloor (I have a gigantic basement you can walk through) , then it doesn't really matter too much where it goes as it is pretty simple to run ethernet cables to any room in the house for just the cost of the cable and the time to drill sme holes in the floor. In that situation then you just want to place it somewhere fairly unobtrusive, in a cupboard or something.



1545 posts

Uber Geek

Trusted

  # 685384 13-Sep-2012 10:05
Send private message

linw: Surely, you are going to need an ethernet cable to the modem and network as well? In that case, why is it easier to run this cable FROM the TV area rather than TO it?

Or are you suggesting the modem also lives behind the TV, and the rest of the network is fed via wireless?


Correct, planning on putting the "genius" in the TV cabinet, up till now the phone/router has been in the kitchen which we are trying to keep clutter free...

Create new topic



Switch your broadband provider now - compare prices


Twitter and LinkedIn »



Follow us to receive Twitter updates when new discussions are posted in our forums:



Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:



Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:





News »

Chorus to launch Hyperfibre service
Posted 18-Nov-2019 15:00


Microsoft launches first Experience Center worldwide for Asia Pacific in Singapore
Posted 13-Nov-2019 13:08


Disney+ comes to LG Smart TVs
Posted 13-Nov-2019 12:55


Spark launches new wireless broadband "Unplan Metro"
Posted 11-Nov-2019 08:19


Malwarebytes overhauls flagship product with new UI, faster engine and lighter footprint
Posted 6-Nov-2019 11:48


CarbonClick launches into Digital Marketplaces
Posted 6-Nov-2019 11:42


Kordia offers Microsoft Azure Peering Service
Posted 6-Nov-2019 11:41


Spark 5G live on Auckland Harbour for Emirates Team New Zealand
Posted 4-Nov-2019 17:30


BNZ and Vodafone partner to boost NZ Tech for SME
Posted 31-Oct-2019 17:14


Nokia 7.2 available in New Zealand
Posted 31-Oct-2019 16:24


2talk launches Microsoft Teams Direct Routing product
Posted 29-Oct-2019 10:35


New Breast Cancer Foundation app puts power in Kiwi women's hands
Posted 25-Oct-2019 16:13


OPPO Reno2 Series lands, alongside hybrid noise-cancelling Wireless Headphones
Posted 24-Oct-2019 15:32


Waikato Data Scientists awarded $13 million from the Government
Posted 24-Oct-2019 15:27


D-Link launches Wave 2 Unified Access Points
Posted 24-Oct-2019 15:07



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.


Support Geekzone »

Our community of supporters help make Geekzone possible. Click the button below to join them.

Support Geezone on PressPatron



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.