Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.




4025 posts

Uber Geek
+1 received by user: 1076

Trusted

# 136718 6-Dec-2013 16:35
Send private message

Looking at the location of this place, its just around the corner from the phone exchange, so its in a VDSL zone. i count 350m by road either way around the block, so i estimate 600m max as a safe estimate.

Except it has approx 13 megabit syncrate. Which seems about 5Mbps or more slower than what i'd expect. About the same speed as this person had in their old place on the same exchange, but 1.1-1.5km away. Its a single person flat, so has one phone jack. Checking the wiring, it goes up into the roof, then down to the end of the building, and i believe into this bell terminal:


(click for big)

Which i groaned when i saw, because everyone knows how old these things are and what the materials and condition can be.

So question is - Can this be bypassed? Would it be bypassed when a splitter/VDSL is installed, so the signal wasn't completely useless? Or would they just see it and refuse the install?
Though the exchange's VDSL ports are full atm, which is quite a disappointment, i believe ADSL2+ speed still could be increased.

Filter this topic showing only the reply marked as answer View this topic in a long page with up to 500 replies per page Create new topic
 1 | 2 | 3
1539 posts

Uber Geek
+1 received by user: 39

Trusted

  # 946669 6-Dec-2013 16:41
Send private message

Yes a VDSL splitter would bypass that :)



4025 posts

Uber Geek
+1 received by user: 1076

Trusted

  # 946671 6-Dec-2013 16:44
Send private message

I read in this thread
http://www.geekzone.co.nz/forums.asp?forumid=49&topicid=109251
That the lead in can also be of very poor material? When i looked at it, it seemed to be quite a fat black cable, this terminal is feeding at least 6 units.

Is it likely that also would be causing degradation, or is the lead in usually fine (not that itd be touched, just curious).

 
 
 
 


3277 posts

Uber Geek
+1 received by user: 979

Trusted

  # 946672 6-Dec-2013 16:44
Send private message

13 Mbps doesn't necessarily mean VDSL will be a no go. Mine wasn't much more pre-VDSL and I sync at 36Mbps on default TSNRM.

And yeah, I wouldn't think they wouldt refuse install due to that. Seems like just the sort of thing the splitter install is supposed to overcome.



4025 posts

Uber Geek
+1 received by user: 1076

Trusted

  # 946675 6-Dec-2013 16:50
Send private message

Ah right, just wondered if it would be a problem because it was the end of the building where the line splits off to each unit whether there can be problems because its shared. It looks like it might be a single old white cable to the jackpoint anyway (though could have more joins in there).

Well VDSL is a no go until someone hops off... i guess that means a splitter install has to be paid for in full. I'd do it myself with my spare splitter, but too much risk with other houses being present, don't want to touch a multi unit distribution.

310 posts

Ultimate Geek
+1 received by user: 369

Trusted
Chorus NZ

  # 946682 6-Dec-2013 17:01
Send private message

If you live in a VDSL service area then order the service from your ISP.  If we need to install another VDSL line card as part of the provisioning we will.  There is no reason for a customer to be "waiting" for service inside a VDSL coverage area.

(BTW who told you there were no VDSL ports left?)

^GL



4025 posts

Uber Geek
+1 received by user: 1076

Trusted

  # 946686 6-Dec-2013 17:15
Send private message

Snap did. They have signed him onto the VDSL plan (which gives higher data) but they said they were out of VDSL connections and would place him on a wait list for when one becomes available and someone leaves. I assumed this means that there are no ports left, but i'd have to clarify since this is 2nd hand information.

I'll pass this information onto him.

3977 posts

Uber Geek
+1 received by user: 1681

Subscriber

  # 946688 6-Dec-2013 17:26
Send private message

boby55: Yes a VDSL splitter would bypass that :)


No it won't.

That is the terminal that is coming from the cabinet. The splitter will simply connect to one of the pairs in that terminal. What will (should) be 'bypassed' is that old tru-rip cable as the Chorus tech is required to run a new Cat6 cable from your jackpoint to the demarcation point which in this case is that old bell terminal.

825 posts

Ultimate Geek
+1 received by user: 218


  # 946719 6-Dec-2013 18:30
Send private message

Judgeing from the age of that roundall terminal - it is more than likely that the cable is also multipuled into the main cable and isnt on not dedicated cable prs. Which would require grooming of the cable, to make the prs dedicated for xDSL performance. Another hint to this is that this is a 15 Pair terminal you say only feeding 6 units but that other device, still on the wall beside the terminal, is an old 0+2 Unit used to create 2 derived POTS lines from 1 copper circuit (and If it is still alive it has an effect of xDSL, as it also works with by frequency shifting signals that interfare with xDSL sevices in cable prs in close proxsimity)

306 posts

Ultimate Geek
+1 received by user: 66


  # 946779 6-Dec-2013 21:20
Send private message

What area of hamilton east this in - i know the area very well and also a bit about the cables



4025 posts

Uber Geek
+1 received by user: 1076

Trusted

  # 946780 6-Dec-2013 21:21
Send private message

So they might bypass it or they might not, depending on the set up? Its down a 60 to driveway so the incoming cable is never going to be touched at least.

306 posts

Ultimate Geek
+1 received by user: 66


  # 946809 6-Dec-2013 22:12
Send private message

The cable will be in multiple so dont think theyll get good sync without some build work

3977 posts

Uber Geek
+1 received by user: 1681

Subscriber

  # 946810 6-Dec-2013 22:15
Send private message

eXDee: So they might bypass it or they might not, depending on the set up? Its down a 60 to driveway so the incoming cable is never going to be touched at least.


No it definitely will not bypass that terminal as that is the feed to your block of flats. But if that is in multiples that cable will need to be cleaned up otherwise your VDSL will suffer intensely.

Don't over think this too much. Just apply with an ISP and you will get VDSL sooner or later.



4025 posts

Uber Geek
+1 received by user: 1076

Trusted

  # 946812 6-Dec-2013 22:17
Send private message

chevrolux:
eXDee: So they might bypass it or they might not, depending on the set up? Its down a 60 to driveway so the incoming cable is never going to be touched at least.


No it definitely will not bypass that terminal as that is the feed to your block of flats. But if that is in multiples that cable will need to be cleaned up otherwise your VDSL will suffer intensely.

Don't over think this too much. Just apply with an ISP and you will get VDSL sooner or later.


Not my place, its a mates. Im just curious.

Cbfd: The cable will be in multiple so dont think theyll get good sync without some build work

You have a pm.



4025 posts

Uber Geek
+1 received by user: 1076

Trusted

  # 946842 6-Dec-2013 23:34
Send private message

He contacted Snap again, they said they are waiting for a new VDSL Line card to be installed the HNE exchange, and have to wait on this before a port is available. No time estimate.

1312 posts

Uber Geek
+1 received by user: 171


  # 947359 8-Dec-2013 03:02
Send private message

eXDee: He contacted Snap again, they said they are waiting for a new VDSL Line card to be installed the HNE exchange, and have to wait on this before a port is available. No time estimate.


thats funny, one of the slingshot reps told me that ADSL and VDSL used the same ports, my cabinet is apparently out of ports so they were concerned that i might not be able to get VDSL but since i already had a port that wasnt a problem. 





 1 | 2 | 3
Filter this topic showing only the reply marked as answer View this topic in a long page with up to 500 replies per page Create new topic



Twitter »

Follow us to receive Twitter updates when new discussions are posted in our forums:



Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:



Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:





News »

HPE to acquire supercomputing leader Cray
Posted 20-May-2019 11:07


Techweek starting around NZ today
Posted 20-May-2019 09:52


Porirua City Council first to adopt new council software solution Datascape
Posted 15-May-2019 12:00


New survey provides insight into schools' technology challenges and plans
Posted 15-May-2019 09:30


Apple Music now available on Alexa devices in Australia and New Zealand
Posted 15-May-2019 09:11


Make a stand against cyberbullying this Pink Shirt Day
Posted 14-May-2019 20:23


Samsung first TV manufacturer to launch the Apple TV App and Airplay 2
Posted 14-May-2019 20:11


Vodafone New Zealand sold
Posted 14-May-2019 07:25


Kordia boosts cloud performance with locally-hosted Microsoft Azure ExpressRoute
Posted 8-May-2019 10:25


Microsoft Azure ExpressRoute in New Zealand opens up faster, more secure internet for Kiwi businesses
Posted 8-May-2019 09:39


Vocus Communications to deliver Microsoft Azure Cloud Solutions through Azure ExpressRoute
Posted 8-May-2019 09:25


Independent NZ feature film #statusPending to premiere during WLG-X
Posted 6-May-2019 22:13


The ultimate dog photoshoot with Nokia 9 PureView #ForgottenDogsofInstagram
Posted 6-May-2019 09:41


Nokia 9 PureView available in New Zealand
Posted 6-May-2019 09:06


Motorola Solutions joins local partners to deliver advanced communications network in New Zealand
Posted 30-Apr-2019 21:50



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.


Support Geekzone »

Our community of supporters help make Geekzone possible. Click the button below to join them.

Support Geezone on PressPatron



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.