Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.


36 posts

Geek
+1 received by user: 4


Topic # 191870 18-Feb-2016 19:22
Send private message

I *finally* got connected to UFB today and am able to ditch my ADSL model :)

 

I went with Voyager internet's Unlimited 100/20mb UFB package. I am very disappointed that I can barely get above 65 mb down (upload is about 21mb normally)

 

 

[ Router is DSL-2877AL (I supplied it), connected to ONT via. Gigabit port. I ran the tests connected via. ethernet. and shut down apps/other computers that might be consumer bandwidth. Speed has been more or consistent throughout the day. I am in Christchurch. ]

 

Is this normal? Not sure if I am right to be disappointed or if this is in the normal range.


View this topic in a long page with up to 500 replies per page Create new topic
 1 | 2
1478 posts

Uber Geek
+1 received by user: 551


  Reply # 1495185 18-Feb-2016 19:50
One person supports this post
Send private message

It's not. You should get close to the headline speeds. Can you try unplugging the router and plug the computer directly into the ONT? You'll need to set VLAN and start a PPPoE dialer on your computer to connect.

6219 posts

Uber Geek
+1 received by user: 1037

Trusted
Lifetime subscriber

  Reply # 1495190 18-Feb-2016 19:52
One person supports this post
Send private message

I don't know whether this is fact or not, but I was told when mine was installed that it could take up to 24 hours for "updates" before going at full speed.


26634 posts

Uber Geek
+1 received by user: 6139

Moderator
Trusted
Biddle Corp
Lifetime subscriber

  Reply # 1495213 18-Feb-2016 20:18
2 people support this post
Send private message

Behodar:

 

I don't know whether this is fact or not, but I was told when mine was installed that it could take up to 24 hours for "updates" before going at full speed.

 

 

Circuit speed is provisioned at the time of install and never changes. It doesn't need to warm up. smile

 

 


399 posts

Ultimate Geek
+1 received by user: 62


  Reply # 1495216 18-Feb-2016 20:24
One person supports this post
Send private message

My parents have voyager ufb in Whangarei, speedtest is 105/55 to auckland.






xpd

Chief Trash Bandit
8795 posts

Uber Geek
+1 received by user: 1283

Mod Emeritus
Trusted
Lifetime subscriber

  Reply # 1495227 18-Feb-2016 20:43
One person supports this post
Send private message

Talk to Voyager. I've only had to contact them a couple of times but each time they were responsive and helpful.





XPD / Gavin / DemiseNZ

 

For Free Games, Geekiness and Reviews, visit :

 

Home Of The Overrated Raccoons

 

Battlenet : XPD#11535    Origin/Steam/Epic/Uplay : xpdnz


19282 posts

Uber Geek
+1 received by user: 2600
Inactive user


Reply # 1495298 18-Feb-2016 22:02
Send private message

sbiddle:

Behodar:


I don't know whether this is fact or not, but I was told when mine was installed that it could take up to 24 hours for "updates" before going at full speed.



Circuit speed is provisioned at the time of install and never changes. It doesn't need to warm up. smile


 



Might need an oil change

3210 posts

Uber Geek
+1 received by user: 616

Trusted

  Reply # 1495326 18-Feb-2016 23:24
2 people support this post
Send private message

What is your router rated to handle?

 

I dont know that model very well but some cheap routers cannot handle 100mbits through them.





Ray Taylor
Taylor Broadband (rural hawkes bay)
www.ruralkiwi.com

There is no place like localhost
For my general guide to extending your wireless network Click Here




2831 posts

Uber Geek
+1 received by user: 1066

Subscriber

  Reply # 1495346 19-Feb-2016 00:59
One person supports this post
Send private message

raytaylor:

 

What is your router rated to handle?

 

I dont know that model very well but some cheap routers cannot handle 100mbits through them.

 

 

 

 

Most likely this.

 

 

 

One way of testing - start a speedtest. At the same time try loading and browsing your routers admin web pages. If they take ages to load while a speedtest is running. Yet load quickly otherwise. Then your routers processor is overloading. Time for a new router.






719 posts

Ultimate Geek
+1 received by user: 174

Trusted
Full Flavour

  Reply # 1495355 19-Feb-2016 05:30
Send private message

Not sure if this is coincidence, but for some reason Voyager score badly with Google on the Video Quality Report - I noticed this in Tauranga and Christchurch recently.



36 posts

Geek
+1 received by user: 4


  Reply # 1495454 19-Feb-2016 09:54
Send private message

Aredwood:

 

raytaylor:

 

What is your router rated to handle?

 

I dont know that model very well but some cheap routers cannot handle 100mbits through them.

 

 

 Most likely this.

 

 One way of testing - start a speedtest. At the same time try loading and browsing your routers admin web pages. If they take ages to load while a speedtest is running. Yet load quickly otherwise. Then your routers processor is overloading. Time for a new router.

 

 

Router admin loads fine when speedtesting. I am getting a gigabit Mikrotik router from work to try see if it makes a difference. 

 

Voyager responded and asked me to run a speedtest against the WorldNet server in Auckland ... same ~65mb result.




36 posts

Geek
+1 received by user: 4


  Reply # 1496023 20-Feb-2016 00:29
Send private message

Guys, I switched to the Mikrotik router and am now getting much better speeds (93mb down, see screenshot below). Still quite a bit less than the advertised speeds which is a little disappointing from a geeky point of view (not so much from a practical point of view). The router CPU load is about 50% when running the speed test.

 

 

 


26634 posts

Uber Geek
+1 received by user: 6139

Moderator
Trusted
Biddle Corp
Lifetime subscriber

  Reply # 1496045 20-Feb-2016 05:52
Send private message

93Mbps is a fairly certain indicator of a 100Mbps FE capable device (as it's all you can do over 100Mbps Ethernet) or dodgy cable. What type of router are you using and how is it connected?

 

 

 

 


7678 posts

Uber Geek
+1 received by user: 2527

Subscriber

  Reply # 1496049 20-Feb-2016 06:39
Send private message

check if you are connected at 100mbps or 1gbps, try changing the cables as well as you may have a ISP supplied cable in there that is only 100mbps capable




36 posts

Geek
+1 received by user: 4


  Reply # 1496269 20-Feb-2016 14:51
Send private message

Jase2985:

 

check if you are connected at 100mbps or 1gbps, try changing the cables as well as you may have a ISP supplied cable in there that is only 100mbps capable

 

 

 

 

Thanks for the tip. Switched to a brand new cat6 cable. Unfortunately same result. The router reports gigabit connections on all connected ports.

 

Will try a different computer and see if the result change.




36 posts

Geek
+1 received by user: 4


  Reply # 1496270 20-Feb-2016 14:52
Send private message

sbiddle:

 

93Mbps is a fairly certain indicator of a 100Mbps FE capable device (as it's all you can do over 100Mbps Ethernet) or dodgy cable. What type of router are you using and how is it connected?

 

 

I am using a Mikrotik RB951G-2HnD. It should easily handle routing far more than 100mb ethernet.

 

One  cat6 cable to the ONT to the router, one cat6 cable to my computer. Low CPU load on router during speed test. 


 1 | 2
View this topic in a long page with up to 500 replies per page Create new topic

Twitter »

Follow us to receive Twitter updates when new discussions are posted in our forums:



Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:



Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:





News »

Hawaiki Transpacific cable ready-for-service
Posted 20-Jul-2018 11:29


Microsoft Dynamics 365 Business Central launches
Posted 10-Jul-2018 10:40


Spark completes first milestone in voice platform upgrade
Posted 10-Jul-2018 09:36


Microsoft ices heated developers
Posted 6-Jul-2018 20:16


PB Technologies charged for its extended warranties and warned for bait advertising
Posted 3-Jul-2018 15:45


Almost 20,000 people claim credits from Spark
Posted 29-Jun-2018 10:40


Cove sells NZ's first insurance policy via chatbot
Posted 25-Jun-2018 10:04


N4L helping TAKA Trust bridge the digital divide for Lower Hutt students
Posted 18-Jun-2018 13:08


Winners Announced for 2018 CIO Awards
Posted 18-Jun-2018 13:03


Logitech Rally sets new standard for USB-connected video conference cameras
Posted 18-Jun-2018 09:27


Russell Stanners steps down as Vodafone NZ CEO
Posted 12-Jun-2018 09:13


Intergen recognised as 2018 Microsoft Country Partner of the Year for New Zealand
Posted 12-Jun-2018 08:00


Finalists Announced For Microsoft NZ Partner Awards
Posted 6-Jun-2018 15:12


Vocus Group and Vodafone announce joint venture to accelerate fibre innovation
Posted 5-Jun-2018 10:52


Kogan.com to launch Kogan Mobile in New Zealand
Posted 4-Jun-2018 14:34



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.