Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.


Galaxytramp

4 posts

Wannabe Geek


#60491 27-Apr-2010 00:18
Send private message

Hi

I have been following this thread with interest
http://www.geekzone.co.nz/forums.asp?forumid=50&topicid=56758&page_no=1

Anyway I took the plunge and purchased a Radeon HD 4550 and installed it. I think this might have been a costly mistake because the Dell no longer boots. It just makes noises like a jet on take off and the power button glows yellow.

I have visually checked the capicitors on the board and cannot see any that are misshapen or leaking so is it possible I may have simply blown the PSU or am I looking at buying a new PC to fit around my new graphics card :(

GT

Create new topic
Galaxytramp

4 posts

Wannabe Geek


  #323317 27-Apr-2010 00:29
Send private message

Actually a GX280 Mini tower slip of the fingers and unable to edit post

Ragnor
8035 posts

Uber Geek

Trusted

  #323323 27-Apr-2010 00:41
Send private message

So does it boot normally once you've taken the new gfx card out?

If so re-install it again and triple check it's seated in the slot fully.

Other things that come to mind are, is the psu powerful enough to drive the card + all the other devices you have in the case?

 
 
 
 


Galaxytramp

4 posts

Wannabe Geek


  #323328 27-Apr-2010 01:13
Send private message

Hi

I took the card out immediately and rebooted but the damage has obviously been done. I have attempted to get the thing up and running several times since but without success.

TomHax was obviously lucky with his in that his card worked OK.

The yellow light on the on/off switch is notifying a mobo or PSU failure according to Dell support site, shame that it is not more specific!!

GT

Ragnor
8035 posts

Uber Geek

Trusted

  #323971 28-Apr-2010 02:38
Send private message

It's very unlikley a new video card would just break your PC's motherboard, if installed correctly.

Some questions to ask yourself:

Did you turn off the power at switch on the psu and/or the wall before installing it?
Did you wear an anti static wrist strap to ground yourself?
Were you wearing clothes that might have caused a static build up?
Did you do the install on the floor on carpet?

Alternatively the PC might have been on it's last legs and moving handling the case led to more sudden failure.

Galaxytramp

4 posts

Wannabe Geek


  #323975 28-Apr-2010 04:40
Send private message

Ragnor: It's very unlikley a new video card would just break your PC's motherboard, if installed correctly.

Some questions to ask yourself:

Did you turn off the power at switch on the psu and/or the wall before installing it?
Did you wear an anti static wrist strap to ground yourself?
Were you wearing clothes that might have caused a static build up?
Did you do the install on the floor on carpet?

Alternatively the PC might have been on it's last legs and moving handling the case led to more sudden failure.


Hi Ragnor

Static discharge certainly not the issue here (Marble Floors) Went through my usual discharge proceedures anyway. I have added Ram and all sorts to this and other PC's without any probs at all.

I am beginning to think that the PSU and/or MOBO must have been in their twilight years and the sudden demand to power the new card was just too much for some component or other.

A real and expensive nuisance, resigned myself to buying a new PC now. I would build one but time is not on my side plus components are not cheap here in Spain.

GT

Create new topic




News »

Amazon introduces new Echo devices
Posted 25-Sep-2020 11:56


Mad Catz introduces new S.T.R.I.K.E. 13 Mechanical Gaming Keyboard
Posted 25-Sep-2020 11:34


Vodafone NZ upgrades international submarine network
Posted 25-Sep-2020 09:09


Jabra announces wireless noise-cancelling airbuds, upgrade existing model
Posted 24-Sep-2020 14:43


Nokia 3.4 to be available in New Zealand
Posted 24-Sep-2020 14:34


HP announces new HP ENVY laptops aimed at content creators
Posted 24-Sep-2020 14:02


Logitech introduce MX Anywhere 3
Posted 21-Sep-2020 21:17


Countdown unveils contactless shopping with new Scan&Go tech
Posted 21-Sep-2020 09:48


HP unveils new innovations for businesses adapting to rapidly evolving workstyles and workforces
Posted 17-Sep-2020 15:36


GoPro launches new HERO9 Black camera
Posted 17-Sep-2020 09:45


Telecommunications industry launches new 5G Facts website
Posted 17-Sep-2020 07:56


New Zealand ranks 3rd in world in GSMA index
Posted 15-Sep-2020 10:13


Trend Micro Security Suite adds web monitoring to prevent identity theft
Posted 14-Sep-2020 15:37


NVIDIA to acquire Arm for US$ 40 billion
Posted 14-Sep-2020 12:27


Epson launches its next gen A3+ colour EcoTank multi-function printer
Posted 10-Sep-2020 16:08



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.


Support Geekzone »

Our community of supporters help make Geekzone possible. Click the button below to join them.

Support Geezone on PressPatron



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.