Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.




1969 posts

Uber Geek
+1 received by user: 249

Subscriber

Topic # 112270 3-Dec-2012 13:27
Send private message

Hi,

I was wondering if people could please give me a few pointers to troubleshoot some internet/network issues I'm experiencing in a house I just recently purchased.

I have Orcon ADSL.  My network is both wireless (for two iPhones and one iPad) and Ethernet over power for two desktops, a HTPC, two Xbox 360 (used for Media Center extenders), and one PS3.

The Orcon Genius router is on the top floor next to the phone outlet.  The HTPC is also on the top floor, with one of the Xbox's on the floor directly below it in the master bedroom.  Performance (network, not internet) seems to be very good.  On the same floor (it's a three story place) are the two desktops.  Internet to them is very flaky.  On the ground floor (in my mancave Smile) I have the other Xbox as a Media Center extender, and a PS3.  Network performance to that Xbox is poor at best.  The PS3 hasn't had much attention thus far.

Most things point to poor network performance, but the internet doesn't seem 100% either.  What steps can I take to try and pinpoint where the issue(s) lie?  Are there some basic tests I can do?

Any help would be appreciated.




Cheers.

Create new topic

xpd

Geek,gamer,father
8241 posts

Uber Geek
+1 received by user: 1080

Mod Emeritus
Trusted
Subscriber

  Reply # 726141 3-Dec-2012 13:32
Send private message

The Ethernet Over Power seems to be your problem then.... try removing some of those devices from the network and run a test - any better ? Yes, then start adding the devices back in again until the issue rears its head again... if it does before plugging in all your devices, then the last device is causing an issue on the network.

If you have no change after unplugging devices, then Id suspect its some issue with the EoP or even your power cabling....

Got a long CAT5 cable ? Try it as a test...




XPD / @DemiseNZ / Gavin
 
Corsair Carbide SPEC-02 / Corsair VS550 / G.SKILL Ripjaws X 8GB / Zotac 760GTX AMP! / ASUS H81M-E / Intel Pentium K Anniversay G3258 @3.9Ghz

 

New ! Retro gaming / emulation forums - http://www.xpd.co.nz/

 

Internet provided by : Voyager - VDSL 65/28  -  Musical Support by : Like A Storm - Visual Entertainment by : Plex and Steam and Overwatch




1969 posts

Uber Geek
+1 received by user: 249

Subscriber

  Reply # 726145 3-Dec-2012 13:38
Send private message

xpd: The Ethernet Over Power seems to be your problem then.... try removing some of those devices from the network and run a test - any better ? Yes, then start adding the devices back in again until the issue rears its head again... if it does before plugging in all your devices, then the last device is causing an issue on the network.

If you have no change after unplugging devices, then Id suspect its some issue with the EoP or even your power cabling....

Got a long CAT5 cable ? Try it as a test...


Are you suggesting that maybe one of the EoP devices is not working correctly?

What sort of tests can I run (sorry, a bit of a noob in this area)?  Is there any way to test power cabling?

 
 
 
 


25 posts

Geek
+1 received by user: 1


  Reply # 728031 6-Dec-2012 13:45

I Argree with XPD.

For basic testing you can use "ping" from windows command interface - Click Start , type cmd in the run box and hit enter, in the command line type -> ping x.x.x.x (X=IP address of each device check your router for the IP Range), do this from the pc on the top floor. You wiil see how long it will take from the top floor pc to send a packet to the client and back. And try and do what "XPD: posted : and continue with ping test, see if the reply back from the client improves.

ETHERNET is always a good reliable option.

25 posts

Geek
+1 received by user: 1


  Reply # 728032 6-Dec-2012 13:49

Oh as for the power cabling test, this is easy, if the outlet has power, the cabling is good, EOA is the device which extracts the traffic from the power line, 9 out of 10 it will be your EOA Device.

Fully Operational
3343 posts

Uber Geek
+1 received by user: 1088

Trusted
Vocus
Subscriber

  Reply # 728042 6-Dec-2012 13:57
Send private message

Hi Satch

Have you tried a device attached by Ethernet directly to the Genius router?  How is that?  How about the Wi-Fi devices?

Cheers



Dan

Hawkes Bay
8477 posts

Uber Geek
+1 received by user: 4

Mod Emeritus
Trusted
Subscriber

  Reply # 728043 6-Dec-2012 13:57
Send private message

Llory: Oh as for the power cabling test, this is easy, if the outlet has power, the cabling is good

If thats the case, we should probably disband these guys then. Totally unneeded.

However, in reality, presence of sufficient current is not a reliable indication of the quality (or safety, or reliabiilty) of any power cabling (whether that's for power supply use or otherwise).

As per above recommendations, isolate all networking devices down to ethernet cables (not over power) only, then start adding non ethernet-cable links in one by one, and testing for issues.




Visit http://www.thecloud.net.nz for New Zealand based Hosted Exchange, Virtual Servers, Web Hosting, FTP Backup & more.
(1GB free FTP storage, or larger plans from $5.75)
 
 - Setup your own mailserver at home on Ubuntu Server - full step by step howto here.
 - Have you seen this: Nathan "KFC4LIFE" Dunn.


1909 posts

Uber Geek
+1 received by user: 120

Trusted

  Reply # 729268 9-Dec-2012 13:41
Send private message

tonyhughes:
Llory: Oh as for the power cabling test, this is easy, if the outlet has power, the cabling is good

If thats the case, we should probably disband these guys then. Totally unneeded.

However, in reality, presence of sufficient current is not a reliable indication of the quality (or safety, or reliabiilty) of any power cabling (whether that's for power supply use or otherwise).

As per above recommendations, isolate all networking devices down to ethernet cables (not over power) only, then start adding non ethernet-cable links in one by one, and testing for issues.


And apparently some electrical components are not very good at passing data signals through them. I would try installing some Ethernet cables at least around your top floor or put the modem on ground floor and find a way to get ethernet from there to upstairs. Might not be easy since you have already gone to the trouble of getting the EoP setup, but Cat5e (or better) cable is reasonably reliable if installed properly.




Qualified in business, certified in fibre, stuck in copper, have to keep going  ^_^

20275 posts

Uber Geek
+1 received by user: 3832

Trusted
Subscriber

  Reply # 730001 10-Dec-2012 21:53
Send private message

RCD breakers seem to kill any carrier signals on them. Unless the ethernet over power is on the same breaker you are already pushing stuff uphill with a broom getting them to work.




Richard rich.ms



1969 posts

Uber Geek
+1 received by user: 249

Subscriber

  Reply # 730348 11-Dec-2012 12:20
Send private message

Thanks for all the input so far guys. I'm extremely busy at the moment so won't have time to test a few things out until next week. Will let you know how I get on.

Create new topic



Twitter »

Follow us to receive Twitter updates when new discussions are posted in our forums:



Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:



Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:





News »

Vodafone TV — television in the cloud
Posted 17-Oct-2017 19:29


Nokia 8 review: Classy midrange pure Android phone
Posted 16-Oct-2017 07:27


Why carriers might want to embrace Commerce Commission study, MVNOs
Posted 13-Oct-2017 09:42


Fitbit launches Ionic, its health and fitness smartwatch
Posted 12-Oct-2017 15:52


Xero launches machine learning automation to improve coding accuracy for small businesses
Posted 12-Oct-2017 15:45


Bank of New Zealand uses Intel AI to detect financial crime
Posted 12-Oct-2017 15:39


Sony launches Xperia XZ1, a smartphone with real-time 3D capture
Posted 11-Oct-2017 10:26


Notes on Nokia’s phone comeback
Posted 10-Oct-2017 10:06


Air New Zealand begins Inflight Wi-Fi rollout
Posted 9-Oct-2017 20:16


The latest mobile phones in perspective
Posted 9-Oct-2017 18:34


Review: Acronis True Image 2018 — serious backup
Posted 8-Oct-2017 11:22


Lenovo launches ThinkPad Anniversary Edition 25
Posted 7-Oct-2017 23:16


Less fone, more tech as Vodafone gets brand make-over
Posted 6-Oct-2017 08:16


API Talent Achieves AWS MSP Partner Status
Posted 5-Oct-2017 21:20


Stellar Consulting Group now a Domo Partner
Posted 5-Oct-2017 21:03



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.