Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.




418 posts

Ultimate Geek


# 249421 9-May-2019 22:04
Send private message

tested on multiple devices. Not sure what the problem is, posting some pics of the Cat6 keystone.

 

https://imgur.com/a/XKXq3Sb

 

does the wiring look correct?

 

have i got the correct keystone - how do i know this is a 568A std?

 

do i need a special RJ45 plug since i just used the one i used on Cat5e?

 

 

 

Thanks


View this topic in a long page with up to 500 replies per page Create new topic
 1 | 2
426 posts

Ultimate Geek

Trusted
Emergency Management

  # 2234151 9-May-2019 22:09
One person supports this post
Send private message

Did you use a punchdown tool?

 

Doesn't look like its been punched down well


'That VDSL Cat'
10606 posts

Uber Geek

Trusted
Spark
Subscriber

  # 2234156 9-May-2019 22:21
3 people support this post
Send private message

Looks to me like it's been punched down with a screw driver or small blade rather than a punchdown tool

 

 

 

You should also use cat6 keystones with cat6 cable, there is minor differences in the wire gauge etc. 





#include <std_disclaimer>

 

Any comments made are personal opinion and do not reflect directly on the position my current or past employers may have.


 
 
 
 


213 posts

Master Geek


  # 2234161 9-May-2019 22:30
2 people support this post
Send private message

Aren't socket straight thru so the last pic has [b][g/w][g][b/w] should be as [b][b/w][g][g/w]





Sqishy


'That VDSL Cat'
10606 posts

Uber Geek

Trusted
Spark
Subscriber

  # 2234162 9-May-2019 22:34
One person supports this post
Send private message

sqishy:

 

Aren't socket straight thru so the last pic has [b][g/w][g][b/w] should be as [b][b/w][g][g/w]

 

 

Your right, it's keyed wrong on that side.

 

 

 

 

Bottom jackpoint looks ok though?





#include <std_disclaimer>

 

Any comments made are personal opinion and do not reflect directly on the position my current or past employers may have.


6828 posts

Uber Geek

Trusted
Subscriber

  # 2234180 10-May-2019 06:30
Send private message

Clearly the orange pair in the first pic are not fully punched down, so no connected I suspect, and as per the last photo, you have a pair cluster fyck

 

Cyril


28110 posts

Uber Geek

Moderator
Trusted
Biddle Corp
Lifetime subscriber

  # 2234184 10-May-2019 07:09
Send private message

As mentioned doesn't look like a proper punch down tool has been used, and the and pairs are in the wrong place.

 

 


1205 posts

Uber Geek

Trusted
Subscriber

  # 2234301 10-May-2019 09:28
Send private message

hio77:

 

 

Bottom jackpoint looks ok though?

 

 

 

 

I was going to mention that too. Bottom one looks good from what I can see. Top one - not so much.

 

 


 
 
 
 


Banana?
4803 posts

Uber Geek

Subscriber

  # 2234310 10-May-2019 09:36
One person supports this post
Send private message

Yep, definitely that top socket has been terminated badly. Orange cable looks like no connection, Green and blue cables all mixed up (it's not hard, there's a handy picture of what it should be directly below it).

 

 

 

You will need to check the other end of that run as well to check it has been terminated correctly too. And go to Jaycar and get a punchdown tool.


6828 posts

Uber Geek

Trusted
Subscriber

  # 2234330 10-May-2019 09:47
One person supports this post
Send private message

Even the $3 plastic tools at Mitre10 work well enough for the casual purpose, I was up north visiting family over easter, was asked to sort out the smart tv that was too far from the wifi router, luckily the sky guy had installed two pair cat5e (mediaconnect I think they called it) for the phone to the sky box years back which happened to go directly to where the router was at the other end of the house. I had no tools but down to mitre10 got a couple of mech and faceplates, and a plastic tool, was surprised how well it worked, popped it in my laptop bag for future emergencies. Even though it looks like it was designed for phone (Krone type) it worked perfectly on 110.

 

https://www.mitre10.co.nz/shop/custom-telephone-socket-wiring-tool-white/p/106736

 

Cyril




418 posts

Ultimate Geek


  # 2234721 10-May-2019 20:15
Send private message

Thanks for the replies. the cable had 568-B.2-1 written on it. so i re did the keystone using the proper push down tool, this time as standard B but now i get nothing. not even 10mbps.


22336 posts

Uber Geek

Trusted
Subscriber

  # 2234727 10-May-2019 20:30
One person supports this post
Send private message

Without a tester you have no idea if they are punched down properly or not. If a wrong tool was used then the slot may be damaged.

 

 

The blinking light testers are better than nothing and are a few bucks on trademe and will pick up gross errors like that miswired pair and hanging out orange wire. I would replace the keystones and do it again.




Richard rich.ms

3885 posts

Uber Geek

Subscriber

  # 2234768 10-May-2019 22:41
One person supports this post

gumdigger:

Thanks for the replies. the cable had 568-B.2-1 written on it. so i re did the keystone using the proper push down tool, this time as standard B but now i get nothing. not even 10mbps.



Did you redo the other end to B standard as well? Both ends need to be either A or B.





146 posts

Master Geek


  # 2234784 11-May-2019 01:06
2 people support this post
Send private message

Exactly what @Aredwood just posted above.

 

Just because the cable says B on it doesn't mean it has to be T568B. Any cable can be punched either T568A or T568B but it has to be terminated the same at both ends (so T568A-T568A or T568B-T568B), unless if you're trying to make a crossover cable (which you're not trying to do right now). The biggest thing you want to do is find out if the other end of the cable is being terminated as A or B.

 

In your OP you mentioned that the keystone was Cat6 compliant, but the "plug" was what held an older Cat5 keystone? By plug, I presume you mean the faceplate? If so, the faceplate can be interchangeable, as long as the keystone is Cat6.

 

Where are you based? If you're around Welly, I could lend you a cable tester and a punch tool if you so require it.




418 posts

Ultimate Geek


  # 2234837 11-May-2019 09:30
Send private message

Looks like i have to borrow a cable tester and buy another keystone, although it doesnt look damaged.

 

Yes i did B on both sides of the keystone.

 

By Plug i mean RJ45 crimp Plugs which is on the other side.                                                                                                                                                


6828 posts

Uber Geek

Trusted
Subscriber

  # 2234851 11-May-2019 10:01
One person supports this post
Send private message

OK, so maybe a clear photo of each end of the cable, the keystone with the recent repunch and the RJ45 plug.

 

Cyril


 1 | 2
View this topic in a long page with up to 500 replies per page Create new topic



Twitter and LinkedIn »



Follow us to receive Twitter updates when new discussions are posted in our forums:



Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:



Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:





News »

Industry plan could create a billion dollar interactive games sector
Posted 19-Aug-2019 20:41


Personal cyber insurance a New Zealand first
Posted 19-Aug-2019 20:26


University of Waikato launches space for esports
Posted 19-Aug-2019 20:20


D-Link ANZ expands mydlink ecosystem with new mydlink Mini Wi-Fi Smart Plug
Posted 19-Aug-2019 20:14


Kiwi workers still falling victim to old cyber tricks
Posted 12-Aug-2019 20:47


Lightning Lab GovTech launches 2019 programme
Posted 12-Aug-2019 20:41


Epson launches portable laser projector
Posted 12-Aug-2019 20:27


Huawei launches new distributed HarmonyOS
Posted 12-Aug-2019 20:20


Lenovo introduces single-socket servers for edge and data-intensive workloads
Posted 9-Aug-2019 21:26


The Document Foundation announces LibreOffice 6.3
Posted 9-Aug-2019 16:57


Symantec sell enterprise security assets for US$ 10.7 billion to Broadcom
Posted 9-Aug-2019 16:43


Artificial tongue can distinguish whisky and identify counterfeits
Posted 8-Aug-2019 20:20


Toyota and Preferred Networks to develop service robots
Posted 8-Aug-2019 20:11


Vodafone introduces new Vodafone TV device
Posted 7-Aug-2019 17:16


Intel announces next-generation Intel Xeon Scalable processors with up to 56 cores
Posted 7-Aug-2019 15:41



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.


Support Geekzone »

Our community of supporters help make Geekzone possible. Click the button below to join them.

Support Geezone on PressPatron



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.