Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.




409 posts

Ultimate Geek
+1 received by user: 31

Lifetime subscriber

Topic # 152290 22-Sep-2014 19:05
Send private message

Hi All


Need to replace batteries in rechargeable razor, they look like AA possibly slightly shorter, there is absolutely no useful info on them, they are nicads, and they are not easy to get at when the razor is assembled.


So i am guessing i'll should stick with ni-cads as they are charged within the razor and nicads don't mind overcharging as much as other rechargeables do?
Do they still make Ni-Cads and where would I get them from

Thanks 





'We love to buy books because we believe we’re buying the time to read them.' WARREN ZEVON


Create new topic

Stu

Hammered
4847 posts

Uber Geek
+1 received by user: 991

Moderator
Trusted
Lifetime subscriber

  Reply # 1134010 22-Sep-2014 19:08
Send private message

They look like standard Ni-Cads. Jaycar used to stock them and probably still do. Some shavers need batteries with solder tabs or fly leads but yours just look like stock batteries.

Even Noel Leeming etc should still sell them? Not that I've tried there personally.




Keep calm, and carry on posting.

 

 

 

Click to see full size Click to see full size


207 posts

Master Geek
+1 received by user: 19

Subscriber

  Reply # 1134384 23-Sep-2014 10:38
Send private message

I have purchased replacement shaver batteries from these guys in the past.

http://www.abtecparts.co.nz/

Worked well for me - just needed the model of the shaver.

Good luck! :)

 
 
 
 


Try Wrike: fast, easy, and efficient project collaboration software
3267 posts

Uber Geek
+1 received by user: 77

Trusted

  Reply # 1134846 23-Sep-2014 19:17
Send private message

Bunnings.  You still get NiCd for garden lights.  But you can also use NiMH.  Both are equally susceptible to over charging.  For both the manufacturers say there are no issues with over charging, but that is regarding swelling/leaking/exploding.  It is not regarding reliability or cycle life or retaining capacity.

The difference is NiMH is "green" and there is legislation to use "green" components for all products with some exceptions (which just has more time to migrate due to their safety/risk nature).

NiMH cycle life is 300x, NiCd is 500x.  NiMH has a higher series resistance, but with higher capacity the relative series resistance is lower.  NiCd can have the same capacity as NiMH, but they stopped developing it due to being phased out.

There is no such thing as memory effect any more, it was solved in the 80's.  There is now a different effect that applies to all Ni-based batteries which is reversible by slowly discharging over 20-40 hours, and is not a permanent memory effect.  Ni-based batteries fail because they get constantly charged, better to charge for 1-2 days when running low instead of 24/7.




You can never have enough Volvos!


1052 posts

Uber Geek
+1 received by user: 229


  Reply # 1137432 25-Sep-2014 13:06
Send private message

Alternative is:
just take those batteies out, and power device from 2.4 Volt power supply. Insatall small connector on the body of a shaver.
LM317 with couple of resistors will convert 12V from PC Power Supply or any other 12V 1A adaptor (like those used for routers) into required voltage.
LM317 will need heatsink and cooling fan. Use small plastic box to put that stuff in it. I used box from another power adaptor and silent 12v fan from PC.

Using that solution for more than 10 years now as battery in mine (was 1 x 1.2V)  had died ages ago.

Note: LM-317 can do as  low as 1.25V. With your 2.4 Volts and possible conversion from say 5VDC from PC - you may not even need the fan.

Another thought - you may try at your own risk to power it up from 3.3V PC power supply.

I power screwdriver rated at 3.6V (3x1.2NiMH inside just died) from 5VDC PC Power Supply without voltage conversion - works absolutely fine and power cordless drill (not cordless anymore) from 12 rail on PC power supply.

If I had to buy batteries for all those toools - that will cost me.
Because those devices are all used indoors I did not find any inconvenience of having a wire attached (via plug).
3.5mm receptacle - you can take out of the modem/router or buy for $1.5 - those are easier to install. Wires with the plug - from power supplies - from routers/modems 








Toyota / Lexus Hybrid and EV Battery Expert Battery Test & Repair 

 

 


Create new topic



Twitter »

Follow us to receive Twitter updates when new discussions are posted in our forums:



Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:



Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:





News »

Amazon launches the International Shopping Experience in the Amazon Shopping App
Posted 19-Apr-2018 08:38


Spark New Zealand and TVNZ to bring coverage of Rugby World Cup 2019
Posted 16-Apr-2018 06:55


How Google can seize Microsoft Office crown
Posted 14-Apr-2018 11:08


How back office transformation drives IRD efficiency
Posted 12-Apr-2018 21:15


iPod laws in a smartphone world: will we ever get copyright right?
Posted 12-Apr-2018 21:13


Lightbox service using big data and analytics to learn more about customers
Posted 9-Apr-2018 12:11


111 mobile caller location extended to iOS
Posted 6-Apr-2018 13:50


Huawei announces the HUAWEI P20 series
Posted 29-Mar-2018 11:41


Symantec Internet Security Threat Report shows increased endpoint technology risks
Posted 26-Mar-2018 18:29


Spark switches on long-range IoT network across New Zealand
Posted 26-Mar-2018 18:22


Stuff Pix enters streaming video market
Posted 21-Mar-2018 09:18


Windows no longer Microsoft’s main focus
Posted 13-Mar-2018 07:47


Why phone makers are obsessed with cameras
Posted 11-Mar-2018 12:25


New Zealand Adopts International Open Data Charter
Posted 3-Mar-2018 12:48


Shipments tumble as NZ phone upgrades slow
Posted 2-Mar-2018 11:48



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.