Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.




279 posts

Ultimate Geek
+1 received by user: 39


Topic # 151189 16-Aug-2014 23:04
Send private message

Hi, 
I have an interesting case which I can't seem to work out. Every day at the same time the internet will start going pretty slow, streams will start buffering and shortly after the router will lose its ADSL sync. It'll reconnect in about 2 mins then following that the internet will be as usual again. On ADSL2+ with DSL-N55U as modem-router.

Router log just shows as:
Aug 16 22:59:53 WAN Connection: Ethernet link down.
Aug 16 22:59:53 stop_nat_rules: apply the redirect_rules!
Aug 16 23:01:02 pppd[340]: Connected to 00:aa:bb:01:23:45 via interface eth2.1.1
Aug 16 23:01:15 rc_service: ip-up 481:notify_rc stop_upnp
Aug 16 23:01:15 rc_service: ip-up 481:notify_rc start_upnp
Aug 16 23:02:12 WAN Connection: WAN was restored.

Router has been updated in firmware but still same issue. It's been doing it for quite a few months but it is somewhat inconsistent, sometimes it will stop doing it for a few days and sometimes it will change the time it disconnects each day.

Any suggestions?

- Your ISP and plan
Slingshot, unlimited
- Type of connection (ADSL, ADSL2, VDSL)
ADSL2+
- Your modem DSL stats (do not worry about posting Speedtest, we need sync rate, attenuation and noise margin)
Modulation : ADSL2+
Annex Mode : Annex A/L
Line State : up
Lan Tx : 947732
Lan Rx : 641981
ADSL Tx : 289897
ADSL Rx : 396338
CRC Down : 0
CRC Up : 274
FEC Down : 0
FEC Up : 40551
HEC Down : 15443
HEC Up : 04
SNR Up : 13.1
SNR Down : 12.2
Line Attenuation Up : 13.6
Line Attenuation Down : 22.5
Data Rate Up : 888
Data Rate Down : 14613
- Your general location (or street)
Waikouaiti
- If you are rural or urban
Semi-rural
- If you know your connection is to an exchange, cabinet or conklin
Cabinet
- If your connection is to a ULL or wholesale service
Wholesale
- If you have done an isolation test as per the link above
Yes

Create new topic
Meow
7101 posts

Uber Geek
+1 received by user: 3345

Moderator
Trusted
Lifetime subscriber

  Reply # 1109725 16-Aug-2014 23:06
Send private message

Do what this says, the robot missed you for some reason.

PeterReader: Hello... Our robot found some keywords in your post, so here is an automated reply with some important things to note regarding broadband speeds.

If you are posting regarding DSL speeds please check that

- you have reset your modem and router
- your PC (or other PCs in your LAN) is not downloading large files when you are testing - you are not being throttled by your ISP due to going over the monthly cap
- your tests are always done on an ethernet connection to the router - do not use wireless for testing
- you read this topic and follow the instructions there.

Make sure you provide information for other users to help you. If you have not already done it, please EDIT your post and add this now:

- Your ISP and plan
- Type of connection (ADSL, ADSL2, VDSL)
- Your modem DSL stats (do not worry about posting Speedtest, we need sync rate, attenuation and noise margin)
- Your general location (or street)
- If you are rural or urban
- If you know your connection is to an exchange, cabinet or conklin
- If your connection is to a ULL or wholesale service
- If you have done an isolation test as per the link above

Most of the problems with speed are likely to be related to internal wiring issues. Read this discussion to find out more about this. Your ISP is not intentionally slowing you down today (unless you are on a managed plan). Also if this is the school holidays it's likely you will notice slower than usual speed due to more users online.

A master splitter is required for VDSL2 and in most cases will improve speeds on DSL connections. Regular disconnections can be a monitored alarm or a set top box trying to connect. If there's an alarm connected to your line even if you don't have an alarm contract it may still try to connect so it's worth checking.

I recommend you read these two blog posts:

- Is your premises phone wiring impacting your broadband performance? (very technical)
- Are you receiving a substandard ULL ADSL2+ connection from your ISP?




20726 posts

Uber Geek
+1 received by user: 4017

Trusted
Subscriber

  Reply # 1109726 16-Aug-2014 23:09
3 people support this post
Send private message

It will probably be an alarm system on the line if its the same time everyday. You may not have it configured to be monitored but it still will be trying.




Richard rich.ms

 
 
 
 


4626 posts

Uber Geek
+1 received by user: 1396


  Reply # 1109771 17-Aug-2014 07:38
One person supports this post
Send private message

richms: It will probably be an alarm system on the line if its the same time everyday. You may not have it configured to be monitored but it still will be trying.


This. A master filter installed at the demarc with the alarm on the voice side will avoid this issue.



279 posts

Ultimate Geek
+1 received by user: 39


  Reply # 1109901 17-Aug-2014 12:51
Send private message

RunningMan:
richms: It will probably be an alarm system on the line if its the same time everyday. You may not have it configured to be monitored but it still will be trying.


This. A master filter installed at the demarc with the alarm on the voice side will avoid this issue.


There's no alarm system that I know of? Cable comes in window then goes into a inline filter with one end going into phone and other into modem router. 

4626 posts

Uber Geek
+1 received by user: 1396


  Reply # 1109909 17-Aug-2014 13:22
Send private message

Xeon:There's no alarm system that I know of? Cable comes in window then goes into a inline filter with one end going into phone and other into modem router. 


In the window? Really? There should be a demarc point of some description between the Chorus network and the internal building wiring - do you know where this is?



279 posts

Ultimate Geek
+1 received by user: 39


  Reply # 1109916 17-Aug-2014 13:48
Send private message

RunningMan: In the window? Really? There should be a demarc point of some description between the Chorus network and the internal building wiring - do you know where this is?


Well not quite just in the window. There is a demarc point outside and the cable from there comes in the window (to a wall jack not on the wall) then into ADSL inline filter into router/phone. I was more meaning that there is no alarm system I know of.

4626 posts

Uber Geek
+1 received by user: 1396


  Reply # 1109922 17-Aug-2014 13:58
One person supports this post
Send private message

Ah, that makes more sense! If there's no alarm, is there any other pattern to the disconects? When someone uses the phone, or some other appliance? Check the jackpoint you have for any signs of corrosion as well.

20726 posts

Uber Geek
+1 received by user: 4017

Trusted
Subscriber

  Reply # 1109981 17-Aug-2014 16:31
Send private message

No other cables into the point of entry box that could go into the rest of the house to an old alarm system that noone knows about?




Richard rich.ms



279 posts

Ultimate Geek
+1 received by user: 39


  Reply # 1109996 17-Aug-2014 17:45
Send private message

RunningMan: Ah, that makes more sense! If there's no alarm, is there any other pattern to the disconects? When someone uses the phone, or some other appliance? Check the jackpoint you have for any signs of corrosion as well.


Only pattern is the time really. Always the same behavior that the connection will slow down, then disconnect briefly. The disconnect will still happen regardless of the load on the network/phone calls etc.

richms: No other cables into the point of entry box that could go into the rest of the house to an old alarm system that noone knows about?


Fairly sure that it is just the single cable coming in the window and we have never had an alarm system in the house. 

I've put a +5db stability adjustment on it in the past but it made no difference from memory.

7257 posts

Uber Geek
+1 received by user: 2313

Subscriber

  Reply # 1110003 17-Aug-2014 17:52
2 people support this post
Send private message

i doubt the wiring would have been through the window since the house was built. might pay to get up there and take the cover off and check if there is any other wiring there



279 posts

Ultimate Geek
+1 received by user: 39


  Reply # 1110034 17-Aug-2014 18:56
Send private message

Jase2985: i doubt the wiring would have been through the window since the house was built. might pay to get up there and take the cover off and check if there is any other wiring there


The room the cable/router/phone is currently in was rebuilt some years ago and the jack has never got around to being properly put on the wall.

805 posts

Ultimate Geek
+1 received by user: 204

Subscriber

  Reply # 1110040 17-Aug-2014 19:09
Send private message

You never said what time it happens?

but ive seen something similar with a dodgy power supply unit/circuit being effected by ripple control signals (for hot water and night storge control) by not supressing the noise into the Modem/router

7257 posts

Uber Geek
+1 received by user: 2313

Subscriber

  Reply # 1110058 17-Aug-2014 19:52
Send private message

InstallerUFB: You never said what time it happens?

but ive seen something similar with a dodgy power supply unit/circuit being effected by ripple control signals (for hot water and night storge control) by not supressing the noise into the Modem/router


says 2300 in the first post

4626 posts

Uber Geek
+1 received by user: 1396


  Reply # 1110078 17-Aug-2014 20:03
One person supports this post
Send private message

Try changing the time (don't use NTP) in the modem - that should rule it out as being something to do with timing in the modem itself. Not very likely, but worth ruling out.



279 posts

Ultimate Geek
+1 received by user: 39


  Reply # 1110124 17-Aug-2014 21:17
Send private message

RunningMan: Try changing the time (don't use NTP) in the modem - that should rule it out as being something to do with timing in the modem itself. Not very likely, but worth ruling out.


It doesn't have a RTC so all I can do is change the time zone it syncs for.

Create new topic



Twitter »

Follow us to receive Twitter updates when new discussions are posted in our forums:



Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:



Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:





News »

Samsung New Zealand introducing the Galaxy S9 and S9+
Posted 26-Feb-2018 07:00


Fujifilm X beats its best with new top of the range, high-performance camera
Posted 24-Feb-2018 14:05


One million kiwis affected by cybercrime
Posted 24-Feb-2018 13:58


New Zealanders want to engage with government online and via mobile apps
Posted 24-Feb-2018 13:56


Samsung launches Samsung Max
Posted 24-Feb-2018 13:52


CPTPP text and National Interest Analysis released for public scrutiny
Posted 21-Feb-2018 19:43


Foodstuffs to trial digitised shopping trolleys
Posted 21-Feb-2018 18:27


2018: The year of zero-login, smart cars & the biometrics of things
Posted 21-Feb-2018 18:25


Intel reimagines data centre storage with new 3D NAND SSDs
Posted 16-Feb-2018 15:21


Ground-breaking business programme begins in Hamilton
Posted 16-Feb-2018 10:18


Government to continue search for first Chief Technology Officer
Posted 12-Feb-2018 20:30


Time to take Apple’s iPad Pro seriously
Posted 12-Feb-2018 16:54


New Fujifilm X-A5 brings selfie features to mirrorless camera
Posted 9-Feb-2018 09:12


D-Link ANZ expands connected smart home with new HD Wi-Fi cameras
Posted 9-Feb-2018 09:01


Dragon Professional for Mac V6: Near perfect dictation
Posted 9-Feb-2018 08:26



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.