Geekzone: technology news, blogs, forums
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.

21 posts


# 20354 22-Mar-2008 20:19
Send private message

I live in a house which is split into two flats. The other flat has an existing Sky satellite dish, which is conveniently located a couple of metres from my TV.

I figure the easiest way to get myself some digital signal is to pop a splitter on this, and run some cables.

I'm looking at, along with a couple of cables (

Before I go ahead and do this, I want to make sure the current LNB will work, and confirm my assumptions about how things connect up are correct.

Here's a photo of the LNB. I can't quite make the writing out on it, other than it's Sharp branded.

Will the cable running into this have an F-Type connector already on it? I need a ladder to look closer, but if someone on here can tell me it'll make things a lot easier.

What I'm imagining will be needed is just to unscrew the existing cable from the LNB, screw on a new one, screw that to the splitter, and screw the original cable, along with the new one to the other side of the splitter. Run the cable up the wall and through my window, screw to the receiver, and I'll be sorted.

The alternative I guess is to cut the existing cable, and crimp two new plugs on it. Lots of extra effort, but if that needs to be done that should be fine.

Am I right? Am I better to buy a dual LNB?

I will most likely be using a Hauppauge card of some flavour, along with Vista MCE, and am located in Dunedin. DVB-T won't work for me I would imagine due to my location, so DVB-S is the plan.

Create new topic
4025 posts

Uber Geek


  # 118099 22-Mar-2008 20:27
Send private message

That'll be the standard Sky Dual Throat LNB, sharp, as you said. I think if 22khz is sent it switches from the Optus D1 to the Optus B1 or something, but you wouldnt want to do that or your neighbour will loose their sky.

The splitter idea should work file with unscrewing them and adding new cables, we have the same LNB and i'm pretty sure ours has the standard F type, but i havent looked close, someone else will be able to confirm this.

Remember to turn off the supply power option, as your neighbours sky STB will already be doing that (provided they dont switch it off).

21 posts


  # 118109 22-Mar-2008 21:04
Send private message

I don't know if they actually have Sky - would prefer not to mess with their setup too much if at all possible. Would I be better just getting a dual output LNB (like this one)? What's the process to install it? A couple of screws for the LNB itself, screw the old cable along with a new one on? And this will mean we can both do whatever the hell we want with our respective cables, and it'll have no bearing on the other one's signal?

Also, where am I best to purchase from? I just came upon freeviewshop from Googling - anywhere better?


4025 posts

Uber Geek


  # 118131 22-Mar-2008 22:52
Send private message

Freeview shop is apparently good, fairly well known.

Buying a new LNB means you need to realign it. Buying a cable + splitter would be less hassle. And i assume with the dual output you still can only have 1 device powering it.

Cable + Splitter im guessing isnt hard, but all you should need to do is unscrew the current cable, attach a cable to go to a splitter, reattach theirs to a splitter and lay down your own cable. Then just make sure your HTPC/STB isnt supplying power, since theirs will be.

However i must say i've never done it myself, so thats just a guess, plenty of others here have though, so i guess i should stop repling :P

21 posts


  # 118134 22-Mar-2008 23:17
Send private message

What happens if they don't have Sky, so I get my PC to supply power, then they get a Sky decoder (or Freeview box etc) installed, which also supplies power? I'm thinking it's probably the easier option though - just let them know I'm doing it first!

79 posts

Master Geek

  # 118136 23-Mar-2008 01:04
Send private message

Hi you just need to get a splitter which passes power on both ports. the LNB requires 18v for freeview and sky to operate which is on Hpol. I would suggest you leave the dish and cable intact and cut into the cable elsewhere possibley at the base of the mounting hardware and add the splitter there. If you start messing around with the dish you run the risk of moving it of alignment.

hope this helps

2895 posts

Uber Geek

Lifetime subscriber

  # 118143 23-Mar-2008 06:22
Send private message

If you REALLY want to put in a different dual output LNB I would recommend having a sharp one like this. Plus you will also need to change the LNB Clamp as the dual throat LNBs have a smaller neck, you can get them from trademe here.

It's not THAT hard realigning the dish, just need someone in front of the TV when you move it around (very slowly).

If you live in Wellington I can give you one of those clamps, and take that dual throat LNB off your hands :)

It's worth checking if they are using sky or not, since if they are not you could just disconnect straight from the LNB and cable yourself in.

Also the main issue you will have is making good F Type connections at each end, the tools are not cheap, and going for the screw on connectors will only create issues for you down the path.

4025 posts

Uber Geek


  # 118150 23-Mar-2008 08:56
Send private message

kevthesparky: Hi you just need to get a splitter which passes power on both ports. the LNB requires 18v for freeview and sky to operate which is on Hpol. I would suggest you leave the dish and cable intact and cut into the cable elsewhere possibley at the base of the mounting hardware and add the splitter there. If you start messing around with the dish you run the risk of moving it of alignment.

hope this helps

See, heres someone who knows what they are talking about. :)

However i would have thought simply unscrewing the f type on the lnb and adding another cable would be simple, unless you have the tools to put plugs on the end of the cable (crimper needed? Not sure?)

I'm sure they will have sky if they have that LNB and a 60cm dish, i wouldnt think they would buy that LNB if they just had freeview.


21 posts


  # 118154 23-Mar-2008 09:41
Send private message

The dish has been there longer than the current tenants - I assume a previous tenant had Sky.

The reason I was planning on unscrewing things rather than cutting and crimping is that I figure I'm more likely to mess up a crimp than mess up unscrewing a cable. Also, it means when I move out I can take my splitter with me and put it back to what it was originally.

Alright. I might just go ahead, buy a splitter and some cables, track down a card, and have a play next weekend then!

2364 posts

Uber Geek

Lifetime subscriber

  # 118216 23-Mar-2008 13:11
Send private message

Dual output LNB from freeviewshop above outputs vertical polarity on one output and horizontal polarity on the other output. It is designed to be used with a switch that connects each set top box to either output depending on the voltage from the set top box.

Spark FibreMAX using Mikrotik CCR1009-8G-1S-1S+. Apple TV 4, Apple TV 4K, iPad Air 1, iPhone 6s, VodaTV Gen 2. If it doesn't move then its data cabled.

Create new topic

Twitter and LinkedIn »

Follow us to receive Twitter updates when new discussions are posted in our forums:

Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:

Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:

News »

Chorus to launch Hyperfibre service
Posted 18-Nov-2019 15:00

Microsoft launches first Experience Center worldwide for Asia Pacific in Singapore
Posted 13-Nov-2019 13:08

Disney+ comes to LG Smart TVs
Posted 13-Nov-2019 12:55

Spark launches new wireless broadband "Unplan Metro"
Posted 11-Nov-2019 08:19

Malwarebytes overhauls flagship product with new UI, faster engine and lighter footprint
Posted 6-Nov-2019 11:48

CarbonClick launches into Digital Marketplaces
Posted 6-Nov-2019 11:42

Kordia offers Microsoft Azure Peering Service
Posted 6-Nov-2019 11:41

Spark 5G live on Auckland Harbour for Emirates Team New Zealand
Posted 4-Nov-2019 17:30

BNZ and Vodafone partner to boost NZ Tech for SME
Posted 31-Oct-2019 17:14

Nokia 7.2 available in New Zealand
Posted 31-Oct-2019 16:24

2talk launches Microsoft Teams Direct Routing product
Posted 29-Oct-2019 10:35

New Breast Cancer Foundation app puts power in Kiwi women's hands
Posted 25-Oct-2019 16:13

OPPO Reno2 Series lands, alongside hybrid noise-cancelling Wireless Headphones
Posted 24-Oct-2019 15:32

Waikato Data Scientists awarded $13 million from the Government
Posted 24-Oct-2019 15:27

D-Link launches Wave 2 Unified Access Points
Posted 24-Oct-2019 15:07

Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.

Support Geekzone »

Our community of supporters help make Geekzone possible. Click the button below to join them.

Support Geezone on PressPatron

Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.