Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.




4 posts

Wannabe Geek


# 36174 21-Jun-2009 12:35
Send private message

I have 51% signal strength on a brand new 14db aerial with LOS to Ngarara.  I am in the fringe area, but thought I would be okay with the height of the house.  When I got the alignment right by GPS I realised I literally could see the transmitter on the horizon.  This is despite already having an old hills minilink with 20db gain inside and new RF cable, bar a short length thats old but externally sound.

Should I upgrade to a better aerial (if so what Db)?

Should I now go for a masthead amp instead?

Also the aerial has the option of rotation down from the horizontal, should I use this to point at the middle of the mast, which is slightly below my horizon?

Thanks


Create new topic
6681 posts

Uber Geek
+1 received by user: 547

Trusted
Subscriber

  # 227129 21-Jun-2009 12:57
Send private message

Dont worry about signal strength, whats the quality or BER reading, if this is all good then dont worry about signal strength. In the raumati region with LOS a 14dB antenna is more than enough.

The beam width of your antenna is in 10s of degrees, so to play with the elevation will achieve little. Only reason you would need an amplifier is if you had lots of cable or more than 3-4splits.

Edit: I seem to remember I offered to do a free site appraisal with a meter last time, if you still want to know if 51% has a meaningful measurement then I am still happy to measure that for you and make any pointers.

Cheers

Cyril



4 posts

Wannabe Geek


  # 227151 21-Jun-2009 16:03
Send private message

Hi Cyril,

You did indeed, but I felt akward about calling you out when I was planning to replace the damaged aerial myself.

The "Quality" is typically 39%, which is all the analysis that I get from Blaze 2.5. It finds the three Signals, but can't get the channel info, or it finds the channel info but reports there are no channels.

There is about 20m of cable, with a hills amp in the middle. There is a 3 way split, with two channels connected (with 1m and 3m tail) both plugged in. Most of the cable is new and satellite quality (foil + brade wrapped), bar the external run which is partially under the gib board, so I have held off replacing this. Visually this is fine, although I have some doubts as this is steel braided, and clearly old wiring.

I have set the tuning to 64QAM, 3/4 code rate, 1/16 Guard, off center frequency 167(default). Transmission mode is not set.

I suspected the aerial was adequate, hene it sounds like an installation problem

steve

 
 
 
 


6681 posts

Uber Geek
+1 received by user: 547

Trusted
Subscriber

  # 227154 21-Jun-2009 16:17
Send private message

Hi Steve, dont feel akward, reason you are on GZ is you are most likely a bit geeky, so I have the expectation that you want to do a bit more DIY than most, I expect that and am happy to assist locals in that situation.

If you have LOS and are only in Raumati then I would suspect you have the ability of good to excellent reception. Therefore I would suspect your cabling (20m is not a lot) and amp setup. Is the amp actually powered?, if remotely is that all in place and operative, whats its watering state (ie has it had a dose).

PM me if you want a bit of my time to sort it.

Cheers
Cyril



4 posts

Wannabe Geek


  # 227161 21-Jun-2009 17:03
Send private message

amp has power, fuse intact, the magic smoke still inside the transformer. old cable is dry, but am wondering about rodent damage inside the wall to the one remaining old length. may have to pull some more gib board off. the house has been on cable tv for years, so there's no recent history of the cabling working....


will PM you if I get stuck. More I think about it I think the problem is in the cabling. Had heard that Ngarara was powered down for interference problems, which was causing me confusion.

Thanks

Create new topic



Twitter and LinkedIn »



Follow us to receive Twitter updates when new discussions are posted in our forums:



Follow us to receive Twitter updates when news items and blogs are posted in our frontpage:



Follow us to receive Twitter updates when tech item prices are listed in our price comparison site:





News »

Air New Zealand uses drones to inspect aircraft
Posted 17-Jun-2019 15:39


TCL Electronics launches its first-ever 8K TV
Posted 17-Jun-2019 15:18


E-scooter share scheme launches in Wellington
Posted 17-Jun-2019 12:34


Anyone can broadcast with Kordia Pop Up TV
Posted 13-Jun-2019 10:51


Volvo and Uber present production vehicle ready for self-driving
Posted 13-Jun-2019 10:47


100,000 customers connected to fibre broadband network through Enable
Posted 13-Jun-2019 10:35


5G uptake even faster than expected
Posted 12-Jun-2019 10:01


Xbox showcases 60 anticipated games
Posted 10-Jun-2019 20:24


Trend Micro Turns Public Hotspots into Secure Networks with WiFi Protection for Mobile Devices
Posted 5-Jun-2019 13:24


Bold UK spinoff for beauty software company Flossie
Posted 2-Jun-2019 14:10


Amazon Introduces Echo Show 5
Posted 1-Jun-2019 15:32


Epson launches new 4K Pro-UHD projector technology
Posted 1-Jun-2019 15:26


Lenovo and Qualcomm unveil first 5G PC called Project Limitless
Posted 28-May-2019 20:23


Intel introduces new 10th Gen Intel Core Processors and Project Athena
Posted 28-May-2019 19:28


Orcon first to trial residential 10Gbps broadband
Posted 28-May-2019 11:20



Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.


Support Geekzone »

Our community of supporters help make Geekzone possible. Click the button below to join them.

Support Geezone on PressPatron



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.