Geekzone: technology news, blogs, forums
Guest
Welcome Guest.
You haven't logged in yet. If you don't have an account you can register now.


SimonSolar2C

2 posts

Wannabe Geek


#112186 29-Nov-2012 13:06
Send private message

Hi all, I'm a newbie on Geekzone.

I just kicked my phone connection by mistake and the wires pulled out.  Saw there was lots of posts on here about how to connect, but none covered my 4 wire socket.

Any help appreciated because I have no phone at the moment !

A photo is probably the quickest explanation.



See the white wire is on a joiner to a white blue wire going to connection 5
The red green and blue have all come free.

Would love to get this hooked back up quickly.

Thanks in advance

Create new topic
freitasm
BDFL - Memuneh
68816 posts

Uber Geek

Administrator
Trusted
Geekzone
Lifetime subscriber

  #724641 29-Nov-2012 13:08
Send private message

Moved to correct forum.




 

 

These links are referral codes

 

Geekzone broadband switch | Eletricity comparison and switch | Hatch investment (NZ$ 10 bonus if NZ$100 deposited within 30 days) | Sharesies | Mighty Ape | Backblaze | Coinbase | TheMarket | My technology disclosure


Brunzy
968 posts

Ultimate Geek

Trusted

  #724680 29-Nov-2012 14:30
Send private message

Normally , Blue one side
Blue/White the other

 
 
 
 


Oblivian
4309 posts

Uber Geek


  #724684 29-Nov-2012 14:44
Send private message

Itll be daisy chained. All the jacks are now dead I take it? :)

Only need 2 wires for the jack itself, the others will be jumpered using pushconnectors to the next outlet.. just cant remember which. Going by the pic, Id say orange needs to be on 2 9still sleeved and been in a krone punch) and the other 2 were likely in a push connector too (stripped) or twisted cheapo style

Time for Sbiddle or CoffeeBaron to intervine

http://www.telepermit.co.nz/PTC200X12.html

sbiddle
29269 posts

Uber Geek

Moderator
Trusted
Biddle Corp
Lifetime subscriber

  #724722 29-Nov-2012 15:36
Send private message

Typically blue and blute/white are used as the primary pair. But as fact it looks like a DIY job anything could go.

Try punching blue to 2 and then the green and red to 3 and 6.

dolsen
1284 posts

Uber Geek

Trusted
Lifetime subscriber

  #724752 29-Nov-2012 16:32
Send private message



Looking at the picture, and, it is not normal, my suggestion would be to just put the red one on number 2, plug the phone in to it and see if you have a dial tone. The damage to the insulation on that wire makes it look like it has been punched down.

I take it that you did not strip the other 2 wires and they were like that? It looks like there is some oxidation on the bare wires so I think that they have been like that for a while, but, it could just be the photo. You don't strip the wires when you punch them down, but, who knows what has been done here in the past.

If that works, and you have other phones that don't, try holding the blue / green against 1 & 4 and see if the other phone gets a dial tone. Unfortunately, your phone wiring is a non standard mess and it is difficult to work out what is happening there.

techo
46 posts

Geek


  #724840 29-Nov-2012 19:34
Send private message

It looks to me like the typical old 4-wire cable (red, white, blue, green) with the white gel-cap extended onto a white/blue wire. This typically uses the red and white wires which should be punched down onto terminals 2 and 5 on the BT jack

techo
46 posts

Geek


  #724841 29-Nov-2012 19:34
Send private message

It looks to me like the typical old 4-wire cable (red, white, blue, green) with the white gel-cap extended onto a white/blue wire. This typically uses the red and white wires which should be punched down onto terminals 2 and 5 on the BT jack

 
 
 
 


InstallerUFB
833 posts

Ultimate Geek


  #724852 29-Nov-2012 19:55
Send private message

techo: It looks to me like the typical old 4-wire cable (red, white, blue, green) with the white gel-cap extended onto a white/blue wire. This typically uses the red and white wires which should be punched down onto terminals 2 and 5 on the BT jack


absolutly correct - the blue and green wires are not used (i dont know why they have been stripped back)

The white one has been extended to connect it to 2 - the red one goes on 5 - but please use the right tool to connect it - either the cheap 'The Warehouse' version that just push inserts the wires on or the correct Krone (or Cloned version) which inserts and cuts the wire off

SimonSolar2C

2 posts

Wannabe Geek


  #725063 30-Nov-2012 10:47
Send private message

Thanks for all your replies !   Laughing

Yes red onto 2 and white as it was on 5 and I have dial tone again.

I just left the green and blue disconnected.
Perhaps there is a non working extension somewhere, but I only use this jack.  We all use wireless phones these days right? who needs extensions.  Wink

DarthKermit
5312 posts

Uber Geek

Trusted

  #725272 30-Nov-2012 18:40
Send private message

We all use wireless phones these days right? who needs extensions.  Wink


It's a good idea to have one old fashioned corded phone around in the event of a power cut. I have one, but I don't leave it plugged in normally.




Whatifthespacekeyhadneverbeeninvented?


Create new topic





News »

Nanoleaf enhances lighting line with launch of Triangles and Mini Triangles
Posted 17-Oct-2020 20:18


Synology unveils DS1621+ 
Posted 17-Oct-2020 20:12


Ingram Micro introduces FootfallCam to New Zealand channel
Posted 17-Oct-2020 20:06


Dropbox adopts Virtual First working policy
Posted 17-Oct-2020 19:47


OPPO announces Reno4 Series 5G line-up in NZ
Posted 16-Oct-2020 08:52


Microsoft Highway to a Hundred expands to Asia Pacific
Posted 14-Oct-2020 09:34


Spark turns on 5G in Auckland
Posted 14-Oct-2020 09:29


AMD Launches AMD Ryzen 5000 Series Desktop Processors
Posted 9-Oct-2020 10:13


Teletrac Navman launches integrated multi-camera solution for transport and logistics industry
Posted 8-Oct-2020 10:57


Farmside hits 10,000 RBI customers
Posted 7-Oct-2020 15:32


NordVPN starts deploying colocated servers
Posted 7-Oct-2020 09:00


Google introduces Nest Wifi routers in New Zealand
Posted 7-Oct-2020 05:00


Orcon to bundle Google Nest Wifi router with new accounts
Posted 7-Oct-2020 05:00


Epay and Centrapay partner to create digital gift cards
Posted 2-Oct-2020 17:34


Inseego launches 5G MiFi M2000 mobile hotspot
Posted 2-Oct-2020 14:53









Geekzone Live »

Try automatic live updates from Geekzone directly in your browser, without refreshing the page, with Geekzone Live now.


Support Geekzone »

Our community of supporters help make Geekzone possible. Click the button below to join them.

Support Geezone on PressPatron



Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly to your computer or smartphone by using a feed reader.

Alternatively, you can receive a daily email with Geekzone updates.