Hi All,
Hoping someone maybe able to point me in the right direction.

Yesterday, after being in the house we are I, I finally got around to connecting the rear surround speakers (Mission M30's) to the AV receiver (Onkyo TX-NR609).

I then proceeded to run the Full EQ calibration of the setup, and it gave an error on the Surround right (being one of the M30's). So, I switched the speakers around (right became left etc) and ran the test again, and it gave an error on Surround left, thus proving a speaker issue, not a cable issue.

It's only on the pulsing calibration test that the speaker is noticeably muted. If you set the receiver to All Channels, it doesn't seem to bad.

As I am Wellington based, can anyone recommend where I can take the speaker (or both of them) to be checked out?