I've win 10 64bit but have had a few problems but they're more likely related to a dodgy LNB. So, yes, I'm able to collect EPG data but have a had a few strange responses when trying to change parameters. They are...

(Update note: post reboot neither of the following problem re-occurred)

1) Unable to save changes to collection parameters. "The DVB-S tuning parameters have not been updated to the sleected frequency list. Doy ou want to update them?". I can repeatedly select "Yes" or attempt to close the EPGC session and get the same window appearing. The only way out is to select "No" which, of course, discards my changes. See attached screen-shot. ...and then other times, I can select "Yes" and it confirms saving of parameters. See screenshot. All seems to be a bit variable as to how it's going to behave from one minute to the next.

2) Channel Search Error. "No tuner able to tune frequency 11778000 - V". This may be caused by my recently (a few hours ago) replacement quad LNB at the dish but not sure how to investigate this further. Once again, see attached screenshot.

I'll try a reboot to see if this fixes anything and report back. but added the pre-reboot logfile to see if can help which is available here...

https://www.hightail.com/download/ZWJYbUplcTI1bmpyZHNUQw

...and here's the post reboot log including a successful EPG collecion (exit code 0). i.e. Everything working well after new LNB and reboot.

https://www.hightail.com/download/ZWJYbUpXRSt3NUpDaDhUQw

robatbentley:

 

1) Unable to save changes to collection parameters. "The DVB-S tuning parameters have not been updated to the sleected frequency list. Doy ou want to update them?". I can repeatedly select "Yes" or attempt to close the EPGC session and get the same window appearing. The only way out is to select "No" which, of course, discards my changes. See attached screen-shot. ...and then other times, I can select "Yes" and it confirms saving of parameters. See screenshot. All seems to be a bit variable as to how it's going to behave from one minute to the next.

 

After you click 'Yes' in response to 'The DVB-S tuning parameters......' you need to click the 'Update' button on the DVB Satellite tab to put the updated parameters into the Selected Frequencies list at the bottom of the form in the same way you do when you are adding a frequency.

A bit convoluted and not obvious I agree.

Thanks. That does it...!