Install instructions for DVBViewer needed.

Forums › Home Theatre (including HTPC and EPG Collector) › Install instructions for DVBViewer needed.

dogsday

16 posts

Geek

#33198 2-May-2009 18:22

Does anyone know where I can find a good set of NZ installation instructions for DVBViewer.
I’m in a loop where most time I start is it gives me the “no hardware available” message. I can get it working sometimes if I wait a few minutes and ok all the “no hardware messages” - I want to reinstall but need a clear set of instructions so I can get it right. Cheers.

freitasm

BDFL - Memuneh
80652 posts

Uber Geek
+1 received by user: 41045

Administrator

ID Verified

Trusted

Geekzone

Lifetime subscriber

#211755 2-May-2009 18:26

Have you read through the sticky posts in our Freeview forum yet?

Referral links: Quic Broadband (free setup code: R587125ERQ6VE) | Samsung | AliExpress | Wise | Sharesies

Support Geekzone by subscribing (browse ads-free), or making a one-off or recurring donation through PressPatron.

hellonearthisman

1819 posts

Uber Geek
+1 received by user: 52

Trusted

#211772 2-May-2009 20:14

I found the solution to that question on geekzone :) Keep searching you'll find it.

Also look for the one about it resetting after 15mins.

dogsday

16 posts

Geek

#211773 2-May-2009 20:18

As always freitasm, you’re on the money. I spend an hour googling for answers before posting but found nothing, hence the post. In the end there was little need to look much further than geekzone.

For others here is the location for DVBViewer instructions. - http://www.geekzone.co.nz/forums.asp?ForumId=83&TopicId=19328

I still have the “no hardware available” error but now after a reinstall I can at least get it going semi reliably. Thanks.