Configuring Spark fiber in Nighthawk router with Tomato

Forums › Spark New Zealand (including Skinny and BigPipe) › Configuring Spark fiber in Nighthawk router with Tomato

Rmani

295 posts

Ultimate Geek
+1 received by user: 98

ID Verified

Lifetime subscriber

#251527 29-Jun-2019 13:00

Got a Netgear R7000 with Tomato, would like to configure it to use with my existing spark fiber connection. Any guides or links is much appreciated. TIA.

Rmani

sqishy

530 posts

Ultimate Geek
+1 received by user: 193

#2266799 29-Jun-2019 13:09

https://kb.netgear.com/30947/How-do-I-set-up-my-NETGEAR-router-if-I-have-Spark-NZ-Fibre-or-UFB

Rmani

295 posts

Ultimate Geek
+1 received by user: 98

ID Verified

Lifetime subscriber

#2266809 29-Jun-2019 13:38

sqishy:

https://kb.netgear.com/30947/How-do-I-set-up-my-NETGEAR-router-if-I-have-Spark-NZ-Fibre-or-UFB

Thanks, but would this be the same even if I had Tomato firmware on it.

Rmani

cyril7

9073 posts

Uber Geek
+1 received by user: 2499

ID Verified

Trusted

Subscriber

#2266866 29-Jun-2019 16:19

Hi don't have a tomato router to hand currently, but just setup a pppoe as usual and under advanced settings you should find vlan, in there set the wan interface to vid 10.

Cannot remember if you can then return to the pppoe and accociate it with the vlan rather than just the wan, been a while.

Cyril