config settings for telecom broadband

Forums › Spark New Zealand (including Skinny and BigPipe) › config settings for telecom broadband

tombrownzz

147 posts

Master Geek
Inactive user

#72108 20-Nov-2010 16:48

I just purchased a new router and I am trying to figure out some telecom broadband settings I need. These are some options in my router settings I don't know what to set them at:

eoa or ppoa(I can only choose 1)

There is a "Enter Service Description" field with pppoa_0 and some other underscores and numbers after it. What is it meant to say?

Do I enable or disable Fullcone NAT?

Do I enable Dial on demand (with idle timeout timer)?

Do I enable Use Static IPv4 Address?

Do I enable Enable IGMP Multicast?

Should I tick the box that says "SRA Enable"?

tombrownzz

147 posts

Master Geek
Inactive user

#407127 20-Nov-2010 17:54

Ok I have found out that it's ppoa but I don't know what the other settings are.

doozy

245 posts

Master Geek
+1 received by user: 10

Trusted

#407179 20-Nov-2010 21:27

for a user/password you can use user@xtrabb.co.nz and just put anything in the password field, as for the rest copied from the Telecom help site:

Your modem should come with an instruction manual that shows you how and where to enter the settings.

Operating Mode : G.992.1, G.DMT or ANSI T1.413 iss 2. Not for G.Lite or G.992.2

VPI : 0

VCI : 100

Encapsulation : RFC 2364 (or 'PPPoverATM', also known as 'PPPoA')

Tarawera Ultra 2015 done, bring on 2016