#
, Strange things are hapening.i can get vfx to work using one modem (belkon) but canot get it to work with my thompson/speedtouch 510
Well this is the story
i run the PAP2T behined my router (belkin router) then connect the belkin router to the belkin modem through the wan port on the router.
the Pap2t will show a light on the line one side within 5 secounds of plugging the phone in but if i use the thompson/speedtouch 510 it doesnot show up even if i wait an hour
things i have tried
reset pap2t settings, power cycle pap2t router and modem.
still no go
notes
if i plug the pap2t directly into the thompson 510 th the phone line one light turns on but with out the router a hole lot of funky stuff goes on.
if i get the light to turn on with the belkin modem with the pap2t behined the router then unplug the belkin modem and plug in the thompson modem the light remains on , on the pap2t and i can get i dial tone using the pap2t strange,
going from this because the pap2t light will come on with out the router and if i replace the thompson modem with the belkin modem while everything is on it works fine until i power cycle a component.
seems to me that the router and the thompson modem are having issues is there somthing i can do other than upgrading the firm ware? i have the secound to latest firmware but dont like the lastest firm ware as it does not show as many technical details i.e sound noise ratio's autention etc.
any ideas?
cheers
