I noticed a new firmware is available fro the WRP400, though I understand the updates need to be provisioned to the router by Xnet, is there usually a long delay? the list of improvements/fixes is quite impressive:
(Taken from release PDF @linksys.com)
The following new features were added:
•• Added the ability to configure a wireless “guest network” to allow guests to connect to the Internet whilepreventing access to your local network. For instructions, see the WRP400 User Guide.
•• Added provisioning support for configuring router/data parameters via open (XML-style) format .
•• Added VLAN support through a VLAN ID that is included in all outgoing packets. You can configure thisVLAN ID through remote provisioning.
Enhancements and Bug Fixes
•• Upgraded the wireless driver to version 2.0.7-1.
•• Upgraded the voice module version 1.0.12(20080529a).
•• Updated all Help content in the web-based utility.
•• Edited the GUI to address minor issues.
•• Modified the IGMP Proxy switch control mechanism to enhance Triple Play performance. Now the routerdirects multicast packets to the respective LAN ports without using the CPU’s multicast routing.
•• Added support for router syslog and debug log.
•• Added support for WPS in the web-based utility.
•• Added PPPoE Relay in the Advanced Routing page.
•• Added DNS Proxy to the Basic Setup page.
•• Added ability to detect active LAN clients through the Diagnostics page.
•• Fixed an issue with the Internet Access Restriction feature.
•• Fixed an issue with DMZ by MAC with a static LAN IP.
•• Fixed an issue with incoming logging when Port Range Triggering is enabled.
•• Fixed a DHCP lease time issue.
•• Fixed an issue with the wireless channel display.
•• Resolved an issue with the MS-CHAP protocol.•• Resolved an issue with MAC clone while using remote management.
•• Resolved an issue with relay of T.38 packets.
•• Fixed an issue with display of time zone settings.
•• Resolved an issue with factory reset through the web GUI.
•• Resolved an issue with Internet Access Restriction when NAT is disabled.
•• Resolved an issue with wireless connectivity after running the setup wizard.
•• Resolved an issue with the web GUI firmware login.
•• Resolved issue with wireless broadcast under the WPA encryption type.
•• Resolved an issue with security LED behavior.
•• Improved DTMF detection during a call.
•• Improved Voice QoS.
•• Fixed an issue with phones displaying incorrect status (fast flashing) when taken off hook.
•• Fixed an issue with custom settings not being saved during configuration backup.
•• Resolved an issue with the restore configuration function.
•• Replaced an expired embedded router certificate.
Trusted
WorldxChange
... but believe it has an issue we are investigating with Linksys so won't be releasing it until we are fully satisfied as it may impact the Voice service.
