Installing Trixbox

Forums › VoIP › Installing Trixbox

AllNightNerding

411 posts

Ultimate Geek

#22601 2-Jun-2008 14:35

Hi There,

Im just following tonys guide on installing trixbox and asterix "http://myasterisk.co.nz/2007/12/12/trixbox-22-vfx-for-dummies-from-install-to-calling-in-less-than-thirty-minutes/"

and am up to the "Type ‘passwd-amp’ (never with the quotes) and enter, create password for the Asterisk management portal (AMP)"

bit

but when I type in passwd-amp in, I get the error "-bash:passwd-amp: command not found, then it starts a new line. have done this several times.

Is there anything that im doing wrong?

-- Divett Enterprises -- The Power Of Tomorrow --

Filterer

489 posts

Ultimate Geek
+1 received by user: 6

#134937 2-Jun-2008 14:57

Read the comments at the bottom of the blog, password-amp is no longer used in the latest versions, by default its amp111. You can change it though editing the configs manually. If you start up with it as the default the management portal will post a small warning on the notice section when you log into the management portal

AllNightNerding

411 posts

Ultimate Geek

#134942 2-Jun-2008 15:03

thanks for that, yea, I didnt read the comments, have read them now :D thanks.

-- Divett Enterprises -- The Power Of Tomorrow --

AllNightNerding

411 posts

Ultimate Geek

#134947 2-Jun-2008 15:14

Now I have to wait till tomorrow for them to change my profile over to asterisk, because the Sales department isnt open on public holidays.

-- Divett Enterprises -- The Power Of Tomorrow --