Hi all,
Just a quick question about the Cisco SRP527W. The 527 has an ADSL modem with the option to swap to Ethernet WAN if required. Only small issue is that when you change to an Ethernet WAN interface it resets the router back to factory defaults. I have tried just downloading the conifg, swapping to ethernet and then upload config but, of course, it reinstates the ADSL modem as the WAN interface.
Is there a way around this or do I just have to re-configure the router. It isn't too much of a big deal but I am lazy and don't like wasting time.

Any help much appreciated.

Thanks,
Sam