Hi,

Followed the whizoo guide http://www.whizoo.com/bt_setup/

can pair TT with belking 003 dongle and 'establish' a connection between. However, when lounching the Palm Web Pro on TT it gives DNS error.

This could be due to the following problem.

Whizoo writes "If you see only your LAN card and your Bluetooth LAN connection, enable ICS on the LAN card by right clicking, select Properties and go to the advanced tab. Check "Allow other network users to connect through this computer's Internet connection". If you have a drop down box, "Home Networking Connection", select your Bluetooth network. You might get some warnings about IP addresses, but go ahead and continue. Do not worry if you do not have the "Home Networking Connection" option. This is not as important as selecting the correct LAN connection to enable ICS on. "

This is my scenerio. But when I try to set ICS on the LAN card it says that this cannot be done because: ICS requires IP 192.168.0.1 which it claims is already taken by another PC on the LAN. But no other PC on the Network has taken this IP as I've checked. Therefore I can't enable ICS on the LAN card.

Infoact whizoo writes to set the 192.168.0.1 in the Bluetooth network settings which I did.

also made edited the script in network properties in TT


SEND CR
DELAY 1
SEND CLIENT
WAITFOR CLIENTSERVER
END

form this ammendment to whizoo guide
http://www.geekzone.co.nz/forums.asp?forumid=8&topicid=243


the Network log on TT is:

S:́̀́ M
S:CLIENT
R:CLIENTSERVER
LCP->CfgReq
LCP->CfgReq
LCP<-CfgRejBadID
LCP<-CfgRej
LCP->CfgReq
LCP<-CfgAck
LCP<-CfgReq
LCP->CfgAck
LCP Up
IPCP->CfgReq
IPCP<-CfgReq
IPCP->CfgAck
IPCP<-CfgRej
IPCP->CfgReq
IPCP<-CfgAck
IPCP Up

Service name: Windows RAS
Local IP address: 192.168.0.1
Gateway address: 0.0.0.0
DNS address:


Help this problem is driving me up the wall, especially as i've managed to establish a connection between the TT and PC.

Another question, how to transfer files between TT and pc?

regards