I have fortigate 60D at home.. Just bought Netgear 4G modem with 2 degree sim card.. for data conneciton..

I have connected to USB but it is not getting connected..

following are the details.

product: http://www.netgear.com/service-providers/products/mobile/usb-modems/320u.aspx

on the firewall

FGT60D4614054581 # diagnose sys modem
The modem state is 6, poll rate is 180000.
The modem is not active.

FGT60D4614054581 # diagnose sys modem external-modem
External modem vendor: Sierra
External modem vendor id: 1199
External modem model : AC313U
External modem product id: 68aa

However the product is Airbus 320U .. on the back of the modem.. I have read some blog and it say it may use different port number even though it share same product ID..

I couldn't find any configuration though.. is there any chance someone can share some expertise to get this configuration corrected..


Configuration:

FGT60D4614054581 (modem) # show
config system modem
    set status enable
    set auto-dial enable
    set redial 1
    set phone1 "*99#"
    set extra-init1 "at+cgdcont=1,\"ip\",\"wap.telecom.co.nz\""
    set altmode disable
end



Errors:

modemd: redails:1  isp:0 dev:/dev/ttyusb0 tel:*99#
modemd: run_state_machine state 0(uninit)
modemd: modem state changed: 0(uninit) -> 1(inactive)
modemd: Launch modem due to auto-dial.
modemd: Begin dialing: redials left = 1
modemd: dev=/dev/ttyusb0 tel=*99#
modemd: modem state changed: 1(inactive) -> 2(dialing)
chat: abort on (BUSY)
chat: abort on (NO DIAL TONE)
chat: abort on (NO DIALTONE)
chat: abort on (NO ANSWER)
chat: abort on (ERROR)
chat: send (atz^M)
chat: expect (OK)
modemd: run_state_machine state 2(dialing)
modemd: run_state_machine state 2(dialing)
modemd: run_state_machine state 2(dialing)
modemd: run_state_machine state 2(dialing)
modemd: run_state_machine state 2(dialing)
modemd: run_state_machine state 2(dialing)
modemd: run_state_machine state 2(dialing)
modemd: run_state_machine state 2(dialing)
modemd: run_state_machine state 2(dialing)