EdgeRouter Lite setting for Spark Fibre

Forums › LAN (ethernet/Wifi/routers/Bluetooth) › EdgeRouter Lite setting for Spark Fibre

rlagksquf

7 posts

Wannabe Geek

#204206 21-Sep-2016 20:59

Hi guys

I recently bought EdgeRouter Lite for my fibre network but I can't seem to figure out how to set it up so I have internet connection.

Would anyone have experience in this particular router?

FYI, I have been given a static IP from Spark .

Thanks very much in advance

Cheers

sbiddle

30853 posts

Uber Geek
+1 received by user: 9996

Retired Mod

Trusted

Biddle Corp

Lifetime subscriber

#1638394 21-Sep-2016 21:03

It's just a standard PPPoE setup on VLAN10. You can use anything you want for the PPPoE username and password.

There have been a number of threads on here recently discussing the config if you search.

GregF

52 posts

Master Geek
+1 received by user: 21

#1638415 21-Sep-2016 21:52

I found this set of notes from Mike Murphy very helpful:

http://www.geekzone.co.nz/forums.asp?forumid=66&topicid=191757

Basically update the firmware to v1.9, and then use the wizard was his advice - works really well.

Cheers, Greg.

rlagksquf

7 posts

Wannabe Geek

#1638423 21-Sep-2016 22:07

Thanks very much guys

I will try those methods

BarTender

3629 posts

Uber Geek
+1 received by user: 2572

ID Verified

Trusted

Lifetime subscriber

#1638431 21-Sep-2016 22:36

I also had to ssh in to make sure hardware acceleration for NAT was turned on. Since before that I didn't get full line speed through the ERL.

Ironically though on the Gigatown line I was testing with I received 940/450Mbit on the HG659b and 880/380MBit with the ERL.

But the ERL is an excellent router from the playing I have had with it.

michaelmurfy

meow
13579 posts

Uber Geek
+1 received by user: 10910

Moderator

ID Verified

Trusted

Lifetime subscriber

#1638436 21-Sep-2016 23:21

I really need to make an official "how to + ISP" thread at some point don't I?

Michael Murphy | https://murfy.nz
Referral Links: Quic Broadband (use R122101E7CV7Q for free setup)

Are you happy with what you get from Geekzone? Please consider supporting us by subscribing.
Opinions are my own and not the views of my employer.

narendrn

12 posts

Geek
+1 received by user: 1

ID Verified

Subscriber

#1638513 22-Sep-2016 08:13

Hi,

I have just configured my Edge router POE with Spark fiber yesterday by just putting down the below necessary details. I have used the Wizard with WLAN 2Lan2 and had worked without any issue.

Operating Mode : MDI/MDIX
PPP Protocol : PPPoE
PPP Username: user@spark.co.nz
PPP Password: password
PPP Auth Type : PAP
Encapsulation : 802.1Q
PCP Marking : 0
VID (or VLAN) : 10
MTU : 1,500 or AUTO

Geekzone

Want to support Geekzone and browse the site without the ads? Subscribe to Geekzone now (monthly, annual and lifetime options).

rlagksquf

7 posts

Wannabe Geek

#1643730 1-Oct-2016 11:28

Thanks guys. working great now..