Hi,

I am on telecom ADSL2+, and I am getting low speeds for my Attenuation:



Mode: ADSL_2plus
Traffic Type: ATM
Status: Up
Link Power State: L0

Downstream Upstream
Line Coding(Trellis): On On
SNR Margin (0.1 dB): 121 126
Attenuation (0.1 dB): 160 36
Output Power (0.1 dBm): 0 128
Attainable Rate (Kbps): 10052 1144

Path 0 Path 1
Downstream Upstream Downstream Upstream
Rate (Kbps): 8316 1081 0 0

MSGc (# of bytes in overhead channel message): 51 10 0 0
B (# of bytes in Mux Data Frame): 148 16 0 0
M (# of Mux Data Frames in FEC Data Frame): 1 8 0 0
T (Mux Data Frames over sync bytes): 2 10 0 0
R (# of check bytes in FEC Data Frame): 12 4 0 0
S (ratio of FEC over PMD Data Frame length): 0.5714 4.0 0.0 0.0
L (# of bits in PMD Data Frame): 2254 280 0 0
D (interleaver depth): 96 1 0 0
Delay (msec): 13.71 1.0 0.0 0.0
INP (DMT symbol): 2.4 0.5 0.0 0.0

Super Frames: 49454 40268 0 0
Super Frame Errors: 0 0 0 0
RS Words: 5637766 805370 0 0
RS Correctable Errors: 0 0 0 0
RS Uncorrectable Errors: 0 0 0 0

HEC Errors: 0 0 0 0
OCD Errors: 0 0 0 0
LCD Errors: 0 0 0 0
Total Cells: 15803696 0 0 0
Data Cells: 743349 0 0 0
Bit Errors: 0 0 0 0

Total ES: 23 1
Total SES: 23 0
Total UAS: 33 33

I was looking at the graph on this post: http://www.geekzone.co.nz/forums.asp?forumid=49&topicid=27834 and it looks like I should be getting 20 Mbits down? Any suggestions?

Thanks

Edit: More info:

- Your ISP and plan

Telecom 150GB + Phone line

- Type of connection (ADSL, ADSL2, VDSL)

ADSL2

- Your modem DSL stats (do not worry about posting Speedtest, we need sync rate, attenuation and noise margin)

Provided.

- Your general location (or street)

Mairehau, Christchurch

- If you are rural or urban

Urban

- If you know your connection is to an exchange, cabinet or conklin

Not sure.

- If your connection is to a ULL or wholesale service

Not sure.

- If you have done an isolation test as per the link above.

Yes, just did one, Attenuation remained the same for downstream, upstream increased to 40.