Solid or stranded wire - In wall Ethernet run

Forums › New Zealand Broadband › Solid or stranded wire - In wall Ethernet run

Starscream122

568 posts

Ultimate Geek
+1 received by user: 101
Inactive user

#225844 7-Dec-2017 14:43

Hi Team

I have wired up a couple of rooms for Ethernet using the ethernet packs you can buy from PB Tech Cat 6 with the ends on them

so I brought 1 30 meter cat 6 cable and 1 20 meter cable and I just cut the ends off and ran them in the walls then terminated them to a keystone jack Tested

with Lan tester all ok also getting gigabit connection speeds.

But... Should I have used solid core cable? the reason I didn't is I didn't want 300 odd meters of Ethernet cable (solid cable is sold by the box)

This is for residential non business use

Thanks.

This is a filtered page: currently showing replies marked as answers. Click here to see full discussion.

LennonNZ

2459 posts

Uber Geek
+1 received by user: 411

ID Verified

Trusted

#1914654 7-Dec-2017 14:56

Stranded Cables are normally used for Patch Cords as they get moved a lot
Solid Cables are normally used for Structured Cables which are not moved.

For your use it makes no difference but punching down stranded cable is not recommended as it can become loose very easily.

RunningMan

9185 posts

Uber Geek
+1 received by user: 4838

#1914680 7-Dec-2017 15:35

xpd:

Not necessarily, Im running twisted under the house,

Twisted is different to stranded. All cable should be twisted pairs - that's what helps with interference rejection. Stranded means the individual conductors are made up of several fine strands, rather than a solid core. Stranded is more flexible, so used for patch cables, but because the individual strands move and deform against each other, they have a tendency to come loose, or cause intermittent connections when punched into IDC type connectors.