I have an iPAQ1940 and a Rikaline bluetooth GPS model 6030 which I have had connected OK, however, for one reason or another I have had to reload software and now cannot get the two units to communicate properly.

They appear to pair OK and the Rikaline is seen by the IPAQ.
Have set as " NMEA 0183v2 Bluetooth" and "Bluetooth Serial Port COM5"
I select NEW > EXPLORE a BLUETOOTH DEVICE > has found Rikaline Bluetooth GPS OK > now service selection when "GPS Serial Output" connection is found and this is wrong it should be "SPP SLAVE" which should be incoming?

I have tried clearing the whole system and starting from scratch but I am still not finding the "SPP SLAVE" connection which is required.

Any decent suggestions?

Adrian