Hey team,

More cleaning out... this is a recently retired HP server.

Has the LFF drive enclosure with 4x 1TB SATA drives - This model only has the HP 120 Array controller which is basically just software over normal SATA ports. If you wanted to use SAS drive you'd need to add a HBA and then plug the enclosure into that. I have a few with LSI 2008 cards inside setup like this.

It has the hot swappable PSU unit installed with 1x 460W PSU. The Hot swap unit runs the full length of the case so it means you lose the 2nd 5.25" bay - but do gain extra PCIE power connectors over the square ATX PSU type.

iLo shows everything working as it should. 2019 Firmware installed and iLo updated to the latest version available for this model. Reasonably quiet after initial boot up so you don't normally need fan mods etc.

Bad bits - Only has 4GB ram and would definitely benefit from more - takes ECC unbuffered which is a bit of a pain to find locally. It is missing the small bracket that screws in over the top of the PCIE slots - and was installed in a 'rural site' It looks like something has tried to make a home in the bottom of the case. I have tried cleaning the marks off with alcohol but no luck.

And lastly one of the rubber feet is missing

$150 pickup Hamilton or I can box and ship it but will need to get quotes for different post codes.

ML310e G8

Xeon E3-1240 v2 4C/8T

4GB Ram (2x2GB - 2 slots free)

4x 1TB 3.5" SATA drives in front bays