I need to configure my silver mySky decoder to turn on the 9v signal on it's RF2 output.
I understand this is supported by the decoder, but it's not one of the options on the standard setup/configuration menus.
Previous posts have included information about how to use the 'installer menu' to enable this option to support TVLink, but I've tried the suggested codes without success. I just can't get to see the required options.
Interestingly, there hasn't been any discussion about TVLink on this forum (that i could find) for several years - I suspect thats due to TVLink using the RF connector and the consequently 'average' picture quality, but I have a situation where it suits.
Can anyone help out?
Thanks!
BTW - I'm in NZ (despite the US flag!?)