Hi, I have recently ordered an Orcon Genius router with an unlimited data plan and VoIP.I was hoping to run an analogue phone using the line out of the Cisco SPA112. I have had no luck when connecting the Cisco SPA112 with ethernet connection to the Orcon Genius and a single Analogue phone plugged into the 'line one' output of the SPA112.
The SPA112 configuration utility shows that 'line one' is not registered and has no tone.
Has anybody had any experience in doing this type of setup. I am a little confused as to what voice settings to put into the SPA112 configuration utility for Orcon.
