Most car manuals also tell you how to change the tyre, and where exactly on the car to put the jack. It can be dangerous if not done right. It is best to get someone to show you, rather than try to do it yourself if you don't know what you are doing. I have seen a wheel come off nearly causing an accident after someone didn't know what they were doing.
merve0o0: I have never owned a car that has had the owners manual in.
I know how to change a tyre the problem is thecar has no jack.
Tha manual that comes in the glovebox of the car is useless to all. I meant get a workshop manual that shows you how to do everything but also includes the maintenance scheules and required tasks (change tyre, check battery, check brake/steering/gearbox fluid etc).
A new gearbox on a simple sedan can cost between 3 and 5 grand. You have to check the fluid from time to time, dont leave everything up to your mechanic, as nice as he may be, he depends on your cars failure.
New tyres, if done right will cost a lot, but in the long run are actually way cheaper than second hands or retreads and do directly save on fuel etc.
Most importantly, learn how to measure your exact fuel consumption and run this test from time to time. An increase in fuel consumption is the first early warning you get that something is amiss and fixing problems early means you save money, time and missed days at work (or missed dates at the movies).
A handy technique if you are still worried about the jack: put the other tire under the car to keep it off the ground if it all goes wrong, then at least you can try again if the handbrake slips or whatever.
1.Txt girl friend telling her to wear skimpy clothing & get over here ASAP! 2.Hand her the wrench. 3.Give her a serious look and point at flat tyer. 4.Grab dads six pack of beers from the fridge. 5.Find a chair. 6.Proceed to give orders to girlfriend.
Cloud spending continues to surge globally, but most organisations haven’t made the changes necessary to maximise the value and cost-efficiency benefits of their cloud investments. Download the whitepaper From Overspend to Advantage now.
I'm pretty sure it was the backing plate of one of the pads, normally on most brakes that plate clips on. On these they're bonded to pad, well all but one was. So I coated all of the pistons and where they met with copper slip, and liberally under the loose pad. Seems to have done the trick. They're on my brother's car, he's away on holiday so it was a good chance to get to the bottom of it. Always something simple.
Are you subscribed to our RSS feed? You can download the latest headlines and summaries from our stories directly
to your computer or smartphone by using a feed reader.