I dun stuffed up real good

Forums › LAN (ethernet/Wifi/routers/Bluetooth) › I dun stuffed up real good

1 | 2

Yabanize

2351 posts

Uber Geek
+1 received by user: 583

#1191721 8-Dec-2014 17:47

lucky015:
1101: IBM/Lenovo used to send out replacement power supples with the voltage set to 110V (US)
I even saw one of there techs get caught out by that : POP
Its something I had to learn the hard way :-(

Ive done that, It does make a lovely pop. Almost as good as the time I accidentally plugged a molex connector in upside down to a running 386, That one ended in smoke.

Molex only goes in one way?

richms

29099 posts

Uber Geek
+1 received by user: 10210

Trusted

Lifetime subscriber

#1191752 8-Dec-2014 19:11

The molex plug is a pretty bad design in that you can get the pins to touch the wrong way around, and there is no easy way to feel the correct way up. Its a crap plug which is why I try to buy PCI cards etc that use the sata plugs instead.

Richard rich.ms

huckster

887 posts

Ultimate Geek
+1 received by user: 460

ID Verified

Lifetime subscriber

#1191804 8-Dec-2014 20:55

richms: The molex plug is a pretty bad design in that you can get the pins to touch the wrong way around, and there is no easy way to feel the correct way up. Its a crap plug which is why I try to buy PCI cards etc that use the sata plugs instead.

MMmmm. The smell of burnt circuitry. Takes ages to go away.....

grudge

266 posts

Ultimate Geek
+1 received by user: 26

#1192001 9-Dec-2014 10:38

Happens to everyone sooner or later.
I fried a Yealink T42G with the power adapter from a Cisco 7940. The one time I didn't check the voltage it happened.

gzt

18684 posts

Uber Geek
+1 received by user: 7824

Lifetime subscriber

#1192007 9-Dec-2014 10:50

In many cases it's not a great idea using adaptors from other equipment even where the printed output specs are the same - last week I resolved an issue with a flaky tplink router simply by using the supplied adaptor. ; ).

Yabanize

2351 posts

Uber Geek
+1 received by user: 583

#1192011 9-Dec-2014 10:56

gzt: In many cases it's not a great idea using adaptors from other equipment even where the printed output specs are the same - last week I resolved an issue with a flaky tplink router simply by using the supplied adaptor. ; ).

A different adaptor with the same voltage worked for a while on my WD elements external drive until it died. Had to take the drive out and buy a new sata/usb board for it. When I tested the adaptor I was using with a multimeter it was giving a higher voltage than it was meant to

1 | 2