Powerline adapter question

Forums › LAN (ethernet/Wifi/routers/Bluetooth) › Powerline adapter question

foxray

6 posts

Wannabe Geek

#215227 18-Jun-2017 09:38

Hello there, I am looking at installing a poweline set to increase coverage down the other end of the house. I am looking at a pass through system as I understand you cannot plug a powerline into a multi board.I already have a TP-Link Wireless N 300Mbps Range Extender that helps but not enough, so can I get a passthrough and then plug the TP-Link into a multi board and run a short Ethernet from it to the passthough powerline?

cadman

1014 posts

Uber Geek
+1 received by user: 557
Inactive user

#1802896 18-Jun-2017 10:03

Using a multibox isn't a problem if they are simply splitters without surge or overload "protection".

Dynamic

4015 posts

Uber Geek
+1 received by user: 1851

ID Verified

Trusted

Lifetime subscriber

#1803228 19-Jun-2017 10:05

Yes, your plan sounds fine to me. (I have several sets of these powerline units in different locations.)

“Don't believe anything you read on the net. Except this. Well, including this, I suppose.” Douglas Adams

Wheelbarrow01

1784 posts

Uber Geek
+1 received by user: 2638

Trusted

Chorus

#1803323 19-Jun-2017 11:24

foxray:

I am looking at a pass through system as I understand you cannot plug a powerline into a multi board.

Thanks! A few months ago when I had fibre installed, I repurposed my powerline adaptor to provide a data connection to my new home theatre amp at the other end of the house. I have not been able to make it connect since then and couldn't work out why, but you've nailed it for me.

When I reconfigured all my wiring in the lounge, I plugged the sender unit into a multi-board but previously it was plugged into the wall. I'll change this and see if it magically comes back to life.

SepticSceptic

2263 posts

Uber Geek
+1 received by user: 779

Trusted

#1803350 19-Jun-2017 12:11

You can use multiway powerboards OK, though look out for ones with Neon power on lights - the neon flash discharge plays merry havoc with the powerline signal.

Had a powerline adapter into a multiway with a neon power indicator, and the speed was really dismal, 1mb/s on average. Up to 7 if I was lucky.

Noticed that the neon would somewhat flash in time with the sync signal on the adapter.

Swapped out the multiway with a another, non-neon one, and all good - at least 30Mbps constant thruput.